The response of soil organic carbon (SOC) decomposition to global warming is a potentially major source of uncertainty in climate prediction. However, the magnitude and direction of SOC cycle feedbacks under climate warming remain uncertain because of the knowledge gap about the global‐scale spatial pattern and temperature sensitivity (Q10) mechanism of SOC decomposition. Here, we collected data of Q10 and corresponding soil variables from 81 peer‐reviewed papers using laboratory incubation to explore how Q10 varied among different ecosystems at the global scale and whether labile and recalcitrant SOC pools had equal Q10 values. Q10 with a global average of 2.41 substantially varied among different ecosystems, ranging from the highest in cropland soils (2.76) and the lowest in wetland soils (1.84). Hump‐shaped correlations of Q10 values with the maximum at SOC = 190 g/kg and the minimum at clay = 37% were observed. However, the main influencing factors of Q10 differed among various ecosystems. Q10 values showed a clear decrease with increasing incubation temperature but no significant decrease above 25°C. In general, labile SOC was less sensitive than recalcitrant SOC to warming. Structural equation model analyses showed that total N and SOC accounted for 53% and 46%, respectively, of the variation in Q10 of labile SOC and recalcitrant SOC. This finding suggested that Q10 values of labile and recalcitrant SOC pools had different controlling factors. Our findings highlighted the importance of Q10’s variations in ecosystem types and the response of recalcitrant SOC to warming in predicting the soil C cycling and its feedback to climate change. Therefore, ecosystem type and difference in Q10 of labile and recalcitrant SOC should be considered to precisely predict the soil C dynamics under global warming. A http://onlinelibrary.wiley.com/doi/10.1111/1365-2435.13256/suppinfo is available for this article.
The 25 April 2015 Nepal earthquake (Mw 7.8) ruptured a segment of the Himalayan front fault zone. Four absolute gravimetric stations in southern Tibet, surveyed from 2010/2011 to 2013 and corrected for secular variations, recorded up to 22.40 ± 1.11 μGal/yr of gravity increase during this period. The gravity increase is distinct from the long‐wavelength secular trends of gravity decrease over the Tibetan Plateau and may be related to interseismic mass change around the locked plate interface under the Himalayan‐Tibetan Plateau. We modeled the source region as a disk of 580 km in diameter, which is consistent with the notion that much of the southern Tibetan crust is involved in storing strain energy that drives the Himalayan earthquakes. If validated in other regions, high‐precision ground measurements of absolute gravity may provide a useful method for monitoring mass changes in the source regions of potential large earthquakes.
This paper presents an in situ falling-head method for measuring hydraulic conductivity of beach sediments in tidal environment. A polyvinyl chloride (PVC) standpipe was vertically pushed into the submerged beach sediments so that its lower part was filled by a sediment column. During the experiment, the sediments were submerged by sea water and the standpipe top was higher than the sea level. The pipe was fully filled with sea water at the beginning of the experiment. Then the water level time series inside and outside the standpipe were recorded. Analytical solutions were derived to describe the relation among the sediment's hydraulic conductivity and the water levels inside and outside the standpipe and used to analyze the experiment data obtained from the intertidal zone of Puqian Bay, Haikou, Hainan Province, China. The water levels predicted by the analytical solution agreed very well with all the experiment data. Experiments for horizontal hydraulic conductivity estimation were also conducted using L-shaped standpipe which bends from vertical to horizontal in the beach sediments. The averaged hydraulic conductivity anisotropy ratio at the study area is about 2.9. After each in situ experiment, the sediments in the standpipe were stored in a plastic box and transported to university laboratory to measure the hydraulic conductivity using falling-head method. It is found that the in situ hydraulic conductivity averages one order of magnitude greater than the laboratory one, indicating that the original beach surface sediments were loose due to tidal and wave actions and that the samples were significantly compacted during the transportation to laboratory.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.