Ozone is a well-known disinfecting agent that is used as an alternative for chlorine in many applications, including water decontamination. However, the utility of ozone in water decontamination is limited by high electrical power consumption and expensive, bulky equipment associated with ozone generation. This study investigates the effectiveness of a lightweight, compact surface dielectric barrier discharge (SDBD) reactor as an ozone generator to inactivate Pseudomonas aeruginosa and methicillin-resistant Staphylococcus aureus (MRSA) in an open water system. Experimental details are provided for ozone generation technique, mixing method, ozone concentrations in air and water, and input energy required to produce adequate ozone concentrations for bacterial inactivation in a contaminated, open water system. Specifically, an active plasma module (APM) reactor system of size 48 cubic centimeters, weighing 55 grams, with a maximum ozone yield of 68.6 g/KWh was used in atmospheric conditions as the source of ozone along with an air pump and a diffusion stone for mixing the ozone in water. Over 4-log reduction in P. aeruginosa concentration was achieved in 4 minutes with 0.1 mg/L ozone concentration in an open water system using 8.8 ± 1.48 J input energy. Also, over 5-log reduction in MRSA concentration was achieved in 2 minutes with 0.04 mg/L ozone concentration in an open water system using 4.4 ± 0.74 J input energy.

We report the experimental characterization of ozone generation in dielectric barrier discharges as a function of the material and characteristics of the dielectric barrier, operating frequency and the power consumed by a surface DBD-plasma reactor in air at atmospheric pressure. To identify the effect of the dielectric barrier, ozone production curves corresponding to ten dielectric barriers with different effective thicknesses and thermal properties are compared and analyzed for two combinations of voltage amplitudes and frequencies: 7 kV/10 kHz and 8.5 kV/14 kHz. The influence of the operating frequency over the ozone generated by a DBD-plasma reactor is studied by varying the frequency in the range 8–20 kHz. The correlation between power measurements and ozone concentrations as well as ozone quenching effects at extreme power conditions are also discussed.

This study introduces spatially targeted decontamination using a synergistic combination of dielectric barrier discharge (DBD) flow actuation and ozone generation. Here, we relate the spatial distribution of local microbial decontaminations in an enclosure to that of local ozone concentrations caused by DBD ozone generation and flow actuation using two reactors with contrasting flow actuation, the Fan and Comb reactors, run at equal power of 1 ± 0.03 W for 3.5 min. Deviations in ozone concentrations and reductions of Escherichia coli on contaminated coupons over two planes were used to quantify the utilization capacity of the generated ozone to simultaneously disinfect regions of a surface placed in the planes. Results show that uniform ozone consumption by a contaminated target, i.e., targeted decontamination, lowers ozone requirements, exposure times, and reactor energy consumption for its disinfection. Furthermore, a significant positive correlation was found between local decontamination and ozone concentrations with Pearson’s correlation, ρ (34) = 0.64; p < 0.001. Simulated ozone distribution using an experiment integrated simulation method, governed by DBD reactor geometry induced flow actuation and ozone reaction rates, is also presented for predicting DBD actuated spatial decontamination distribution. Our study shows an innovative approach of applying DBD plasma reactors for decontamination using flow actuation and ozone generation to achieve targeted killing with maximized ozone utilization lowering overall ozone dosage requirements, energy requirements, and exposure times.