High-temperature measurements above 1000 °C are critical in harsh environments such as aerospace, metallurgy, fossil fuel, and power production. Fiber-optic high-temperature sensors are gradually replacing traditional electronic sensors due to their small size, resistance to electromagnetic interference, remote detection, multiplexing, and distributed measurement advantages. This paper reviews the sensing principle, structural design, and temperature measurement performance of fiber-optic high-temperature sensors, as well as recent significant progress in the transition of sensing solutions from glass to crystal fiber. Finally, future prospects and challenges in developing fiber-optic high-temperature sensors are also discussed.
High temperature detection is a constant challenge for condition monitoring under harsh environments in optical fiber sensors research. In this study, the temperature response characteristics of guided acoustic wave Brillouin scattering (GAWBS) spectra in silica single-mode fiber (SMF) up to 800 °C are experimentally investigated, demonstrating the feasibility of the method for high-temperature monitoring. With increasing temperature, the resonance frequency of GAWBS spectra increases in a nearly linear manner, with linearly fitted temperature-dependent frequency shift coefficients of 8.19 kHz/°C for TR2,7 mode and 16.74 kHz/°C for R0,4 mode. More importantly, the linewidth of the GAWBS spectra is observed to narrow down with increasing temperature with a linearly fitted rate of −6.91 × 10−4/°C for TR2,7 modes and −8.56 × 10−4/°C for R0,4 modes. The signal-to-noise ratio of the GAWBS spectra induced by both modes increase by more than 3 dB when the temperature rises from 22 °C to 800 °C, which indicates that the proposed sensing scheme has better performance in high-temperature environments, and are particularly suitable for sensing applications in extreme environments. This study confirms the potential of high-temperature sensing using only GAWBS in silica fibers without any complex micromachining process, which has the advantages of strong mechanical strength, simple structure, easy operation, and low cost.
A frequency comb generator (FCG) based on dual-cavity Brillouin random fiber lasing oscillation in the 1.5 μm telecon spectral window is established and experimentally demonstrated. In the half-open main cavity of the dual cavity, the stimulated Brillouin scattering in highly nonlinear fiber (HNLF) and Rayleigh scattering in single-mode fiber are employed to provide sufficient Brillouin gain and the randomly distributed feedback, respectively, for random mode resonance. The sub-cavity includes an Er-doped fiber amplifier to couple back and boost lower-order Stokes and anti-Stokes light for the cascade of stimulated Brillouin scattering to generate multiple higher-order Stokes and anti-Stokes light. Meanwhile, efficient four-wave mixing is stimulated in the HNLF-based main cavity, further enhancing the number and intensity of the resonant Stokes and anti-Stokes light. By taking advantages of the unique transmission characteristics of nonlinear optical loop mirrors, the power deviation between Stokes and anti-Stokes lines is further optimized with 17 orders of stable Stokes lines and 15 orders of stable anti-Stokes lines achieved within the 10 dB power deviation, with maximum optical signal-to-noise ratio (OSNR) of ~22 dB and ~17 dB and minimum OSNR of ~10 dB and ~7.5 dB for Stokes and anti-Stokes lines, respectively. In addition, the dynamic characteristics of the proposed FCG have been experimentally investigated. Such an FCG with fixed frequency spacing will find promising applications in fields of optical communication, microwave, optical sensing, etc.
The spectral characteristics of the relative intensity noise (RIN) of two amplified spontaneous emission (ASE) sources are experimentally measured. An Er-doped fiber superfluorescent source (EDF-SFS) is investigated and compared with a super-luminescent diode (SLD) source, using a simple tunable fiber Bragg grating filter-based system. Experimental results based on normal ASE operation conditions showed that the RIN distribution of the EDF-SFS is correlated with its emission spectral profile, which is different from the results observed using the SLD source. This finding shows for the first time that an EDF-SFS based ASE has fundamentally different RIN characteristics from other known existing spontaneous emission broadband sources. The amplifying process of the EDF-SFS is discussed and confirmed using a rate equation-based simulation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.