We developed type-II core−shell nanocrystals (NCs) with a chiral low-dimensional perovskite shell and an achiral 3D MAPbBr 3 core. The core−shell NCs exhibit spin-polarized luminescence at the first excitation band of the achiral core, which is due to the chiral-induced spin selectivity (CISS) effect-governed spin-dependent shell-to-core electron transportation and the subsequent electron− hole recombination in the core. The preferred spin state of the transferred electrons is determined by the handness of the chiral shell. For the core−shell NCs film, a photoluminescence quantum yield (PLQY) of 54% and a circularly polarized luminescence (CPL) with a maximum |g lum | of 4.0 × 10 −3 are obtained at room temperature. Finally, we achieved a spin-polarized light-emitting diode (spin-LED), affording a circularly polarized electroluminescence (CP-EL) with a |g CP-EL | of 6.0 × 10 −3 under ambient conditions.

No abstract

No abstract

Furfural-tolerant strain is essential for the fermentative production of biofuels or chemicals from lignocellulosic biomass. In this study, Zymomonas mobilis CP4 was for the first time subjected to error-prone PCR-based whole genome shuffling, and the resulting mutants F211 and F27 that could tolerate 3 g/L furfural were obtained. The mutant F211 under various furfural stress conditions could rapidly grow when the furfural concentration reduced to 1 g/L. Meanwhile, the two mutants also showed higher tolerance to high concentration of glucose than the control strain CP4. Genome resequencing revealed that the F211 and F27 had 12 and 13 single-nucleotide polymorphisms. The activity assay demonstrated that the activity of NADH-dependent furfural reductase in mutant F211 and CP4 was all increased under furfural stress, and the activity peaked earlier in mutant than in control. Also, furfural level in the culture of F211 was also more rapidly decreased. These indicate that the increase in furfural tolerance of the mutants may be resulted from the enhanced NADH-dependent furfural reductase activity during early log phase, which could lead to an accelerated furfural detoxification process in mutants. In all, we obtained Z. mobilis mutants with enhanced furfural and high concentration of glucose tolerance, and provided valuable clues for the mechanism of furfural tolerance and strain development.

Hydroxytyrosol (HT) is a valuable aromatic compound with numerous applications. Herein, we enabled the efficient and scalable de novo HT production in engineered Saccharomyces cerevisiae (S. cerevisiae) from glucose. Starting from a tyrosol-overproducing strain, six HpaB/HpaC combinations were investigated, and the best catalytic performance was acquired with HpaB from Pseudomonas aeruginosa (PaHpaB) and HpaC from Escherichia coli (EcHpaC), resulting in 425.7 mg/L HT in shake flasks. Next, weakening the tryptophan biosynthetic pathway through downregulating the expression of TRP2 (encoding anthranilate synthase) further improved the HT titer by 27.2% compared to the base strain. Moreover, the cytosolic NADH supply was improved through introducing the feedback-resistant mutant of the TyrA (the NAD + -dependent chorismate mutase/prephenate dehydrogenase, TyrA*) from E. coli, which further increased the HT titer by 36.9% compared to the base strain. The best performing strain was obtained by optimizing the biosynthesis of HT in S. cerevisiae through a screening for an effective HpaB/HpaC combination, biosynthetic flux rewiring, and cofactor engineering, which enabled the titer of HT reaching 1120.0 mg/L in the shake flask. Finally, the engineered strain produced 6.97 g/L of HT by fed-batch fermentation, which represents the highest titer for de novo HT biosynthesis in microorganisms reported to date.

Consolidated bioprocessing (CBP) is a promising technology for lignocellulosic ethanol production, and the key is the engineering of a microorganism that can efficiently utilize cellulose. Development of Saccharomyces cerevisiae for CBP requires high level expression of cellulases, particularly cellobiohydrolases (CBH). In this study, to construct a CBP-enabling yeast with enhanced CBH activity, three cassettes containing constitutively expressed CBH-encoding genes (cbh1 from Aspergillus aculeatus, cbh1 and cbh2 from Trichoderma reesei) were constructed. T. reesei eg2, A. aculeatus bgl1, and the three CBH-encoding genes were then sequentially integrated into the S. cerevisiae W303-1A chromosome via δ-sequence-mediated integration. The resultant strains W1, W2, and W3, expressing uni-, bi-, and trifunctional cellulases, respectively, exhibited corresponding cellulase activities. Furthermore, both the activities and glucose producing activity ascended. The growth test on cellulose containing plates indicated that CBH was a necessary component for successful utilization of crystalline cellulose. The three recombinant strains and the control strains W303-1A and AADY were evaluated in acid- and alkali-pretreated corncob containing media with 5 FPU exogenous cellulase/g biomass loading. The highest ethanol titer (g/l) within 7 days was 5.92 ± 0.51, 18.60 ± 0.81, 28.20 ± 0.84, 1.40 ± 0.12, and 2.12 ± 0.35, respectively. Compared with the control strains, W3 efficiently fermented pretreated corncob to ethanol. To our knowledge, this is the first study aimed at creating cellulolytic yeast with enhanced CBH activity by integrating three types of CBH-encoding gene with a strong constitutive promoter Ptpi.

No abstract

δ-Integration can improve the expression stability and increase the copy number of exogenous genes in Saccharomyces cerevisiae. Generally, δ-integration vectors employ auxotrophic markers, such as LEU2-d, HIS3, TRP1, and URA3, to screen transformants. In this study, two cellulase genes (β-glucosidase and endoglucanase) were integrated into the S. cerevisiae W303-1A chromosome as reporters, by δ-integration with the aforementioned auxotrophic markers. Eight strains, L-BGL, H-BGL, T-BGL, U-BGL, L-EG, H-EG, T-EG, and U-EG, were selected and tested. After 5 days growth, cellulase activities (U ml(-1)) were 3, 2.3, 1.8, 1.5, 29, 12, 8, and 1.5, respectively. The results showed that auxotrophic markers influenced the expression of cellulase genes.