Rapid and sensitive reversed phase high performance liquid chromatography (RP-HPLC) and ultra performance liquid chromatography (RP-UPLC) method with UV detection has been developed and validated for quantification of parathyroid hormone (PTH) in presence of meta-cresol as a stabilizer in a pharmaceutical formulation. Chromatography was performed with mobile phase containing 0.1% Trifluoroacetic acid (TFA) in MilliQ water and 0.1% TFA in acetonitrile with gradient program and flow rate at 0.3 mL/min for HPLC and 0.4 mL/min for UPLC. Quantification was accomplished with internal reference standard (qualified against innovator product and National Institute for Biological Standards and Control (NIBSC) standard). The methods were validated for linearity (correlation coefficient=0.99), range, accuracy, precision and robustness. Robustness was confirmed by considering three factors; mobile phase composition, column temperature and flow rate/age of mobile phase.Intermediate precision was confirmed on different equipments, different columns and on different days. The relative standard deviation (RSD) (<2% for RP-HPLC and <1% for UPLC, n=30) indicated a good precision. Retention time was found about 17 min and 2 min by HPLC and UPLC methods, respectively. Both methods are simple, highly sensitive, precise and accurate and have the potential of being useful for routine quality control.
This paper describes a sensitive spectrophotometric method developed for determination of Ketoconazole (KC) in tablets based on amplification reactions. Ketoconazole was oxidized with periodate, resulting in formation of KC2+ and iodate ions. After masking the excess periodate with molybdate, the iodate was treated with iodide to release iodine. The liberated iodine was transformed to ICl2− species and extracted as ion-pair with rhodamine 6G into toluene for spectrophotometric measurement at 535 nm. A linear calibration graph was obtained between 0.2136 μg/mL and 1.7088 μg/mL of Ketoconazole with a molar absorptivity of 5×105 mol·L−1 cm−1. The procedure was successfully applied for the determination of ketoconazole in tablet formulation.
Aim:To develop and validate a rapid and sensitive reverse phase high performance liquid chromatography (RP-HPLC) method with UV detection for quantification of meta-cresol (m-cresol) in pharmaceutical preparation of parathyroid hormone (1–34) (PTH).Materials and Methods:Chromatography was performed on a Jupiter RP C-18 (4.6 mm ID × 250 mm L, porosity 300 Å, particle size 5 μm) with a guard column (reversed-phase C18 column of 4.6 mm ID × 12.5 mm L, porosity 300 Å, particle size 5 μm) using a mobile phase containing 0.1% TFA in 60% methanol with isocratic program at 1.0 mL/min flow rate. Detection was carried out at 217 nm. The method was validated as per ICH guidelines for linearity (correlation coefficient = 0.99), range, accuracy, precision, and robustness (n = 9 during accuracy parameter whereas n =15 during linearity and range parameter and n = 6 during repeatability). Robustness was confirmed by considering two factors; age effect of the mobile phase and test sample and with different columns during method development.Results:The method was linear over the concentration range of 75–120 μg/mL. The precision of the method in terms of relative standard deviation was evaluated from intra- and inter-day replicate injections of system suitability standards of m-cresol using different equipment and different columns. Components of within- and between-batch variances were found to be below 2% (n = 30) and 3%, respectively, which constituted an acceptable level of variation. Retention time was found to be about 5.2 min and 10.9 min for m-cresol and PTH, respectively.Conclusion:The developed method thus has the potential of being useful for routine quality control of m-cresol.
Rapid and sensitive reverse phase high performance liquid chromatography (RP–HPLC) and ultra performance liquid chromatography (UPLC) methods with UV detection for quantification of erythropoietin (EPO) in presence of human serum albumin (HSA) as a stabilizer in a pharmaceutical formulation of EPO have been developed and validated. Chromatography was performed with mobile phase containing 0.1% Trifluoroacetic acid (TFA) in MilliQ water and 0.1% TFA in acetonitrile with gradient program and a flow rate of 1.5 mL/min for HPLC and 0.35 mL/min for UPLC. Quantification was accomplished with internal reference standard (qualified using EP reference standard). The methods were validated for linearity (correlation coefficient=0.99), accuracy, precision and robustness. Robustness was confirmed by considering three factors; percentages of TFA in mobile phase, age of test sample and mobile phase and column temperature. Intermediate precision was confirmed by different analysts, different equipments and on different days. The relative standard deviation (RSD) value (<2%, n=30) indicated good precision of the developed method. The proposed RP-HPLC method had retention time less than 20 min while the developed UPLC method had retention time less than 4 min. Both the RP-HPLC and UPLC methods were simple, highly sensitive, precise and accurate, suggesting that the developed methods are useful for routine quality control.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.