Fused filament fabrication (FFF) is one of the various types of additive manufacturing processes. Similar to other types, FFF enables free-form fabrication and optimised structures by using polymeric filaments as the raw material. This work aims to optimise the printing conditions of the FFF process based on reliable properties, such as printing parameters and physical properties of polymers. The selected polymer is poly(lactic) acid (PLA), which is a biodegradable thermoplastic polyester derived from corn starch and is one of the most common polymers in the FFF process. Firstly, the maximum inlet velocity of the filament in the liquefier was empirically determined according to process parameters, such as feed rate, nozzle diameter and dimensions of the deposited segment. Secondly, the rheological behaviour of the PLA, including the velocity field, shear rate and viscosity distribution in the nozzle, was determined via analytical study and numerical simulation. Our results indicated the variation in the shear rate according to the diameter of the nozzle and the inlet velocity. The shear rate attained its maximum value near the internal wall at high inlet velocities and smaller diameters. Finally, the distribution of the viscosity along the radius of the nozzle was obtained. At high inlet velocity, several defects appeared at the surface of the extrudates. At the highest shear rates, the extrudates underwent severe deformation. The defects predicted via numerical simulation were reasonably consistent with that observed from an optical microscope. Hence, these results are effective for selecting the printing parameters (i.e. nozzle diameter, feed rate and layer height) to improve the quality of the manufactured parts.

In this paper, the printing temperature ranges of PLA and PEEK, two semi-crystalline thermoplastics, have been investigated for the Fused Filament Fabrication (FFF) process. The printing range, comprised between the melting temperature and the degradation of each polymer, is 160°C to 190°C for PLA and 350°C to 390°C for PEEK. The complex viscosity has been measured for both polymers within the printing range. The kinetics of coalescence has been registered by measuring the bonding length between two filaments of the same polymer according to the temperature. At 167°C, the filaments of PLA reached the maximum value of bonding length. For PEEK, the filaments reached the maximum value of bonding length at 380°C. For the both materials, the final height of the filament is 80% of the initial diameter. The comparison of the obtained results with experimental study and predictive model shows a good agreement when the polymer is totally in fusion state.