To the best of the author's knowledge, several studies during 1960-2019 were carried out on wideband and ultrawideband LNAs just to render optimum LNAs for SAW-less Radio-Frequency Integrated Circuits (RFICs) but none of these works reviewed and taught the proceedings of these six decades, hence the lack of a comprehensive review is quite noticeable. This article specifically studies the challenges and solutions of designing UWB LNA by reviewing topologies and techniques such as inductive peaking, noise and distortion cancellation, g m -boosting, active inductor and notch filter. Its historical aspect illustrates when the idea of wideband LNA was born and how it changed to ultrawideband LNA, and its tutorial aspect discusses circuits and achievements to present optimum LNAs in Complementary MOS (CMOS), BiCMOS and High-Electron-Mobility Transistor (HEMT) technologies. This work describes the endeavours of engineers in reaching UWB LNA from narrowband LNA during six decades that have great importance as a chapter in understanding this topic because it teaches all topologies, techniques, circuits and related events in a historical narrative for trained readers who are not experts on this topic. | UWB LNA | In the 1960sWhere did the idea of 'transistorised wideband LNA' originate from? It seems that everything goes back to the 1960s when This is an open access article under the terms of the Creative Commons Attribution License, which permits use, distribution and reproduction in any medium, provided the original work is properly cited.

The goal is to illustrate new errors about using the figures-of-merit NF and IIP, by investigating an AGC-less microwatt ultrawideband g m -boosted CMOS RF system with noise/distortion cancellation. The system composed of limiter and LNA is designed for 0.3-10.7 GHz at 1.8 V. Thanks to the limiter, the impact of noises and distortions is cancelled and the LNA acts linear without any saturation or block, as well as, it becomes AGC-less. Additionally, achievements prove that NF and IIP sometimes can be accompanied by error, hence engineers must always consider all aspects of a system together during their evaluations. Although this work is not experimental, it applies different methods such as "Regenerating", "Comparing Calculations with Simulations" and "Monte Carlo" to demonstrate the reliability of achievements for applying in a SAW-less RFIC.

No abstract