Reinforced concrete (RC) beam-column connections especially those without transverse reinforcement in joint region can exhibit brittle behavior when intensive damage is concentrated in the joint region during an earthquake event. Brittle behavior in the joint region can compromise the ductile design philosophy and the expected overall performance of structure when subjected to seismic loading. Considering the importance of joint shear failure influences on strength, ductility and stability of RC moment resisting frames, a finite element modeling which focuses on joint shear behavior is presented in this article. Nonlinear finite element analysis (FEA) of RC beam-column connections is performed in order to investigate the joint shear failure mode in terms of joint shear capacity, deformations and cracking pattern. A 3D finite element model capable of appropriately modeling the concrete stress-strain behavior, tensile cracking and compressive damage of concrete and indirect modeling of steel-concrete bond is used. In order to define nonlinear behavior of concrete material, the concrete damage plasticity is applied to the numerical model as a distributed plasticity over the whole geometry. Finite element model is then verified against experimental results of two non-ductile beam-column connections (one exterior and one interior) which are vulnerable to joint shear failure. The comparison between experimental and numerical results indicates that the FE model is able to simulate the performance of the beam-column connections and is able to capture the joint shear failure in RC beam-column connections.

No abstract

No abstract

No abstract

No abstract

No abstract

No abstract

The solution of the motion equation for a structural system under prescribed loading and the prediction of the induced accelerations, velocities, and displacements is of special importance in structural engineering applications. In most cases, however, it is impossible to propose an exact analytical solution, as in the case of systems subjected to stochastic input motions or forces. This is also the case of non-linear systems, where numerical approaches shall be taken into account to handle the governing differential equations. The Legendre–Galerkin matrix (LGM) method, in this regard, is one of the basic approaches to solving systems of differential equations. As a spectral method, it estimates the system response as a set of polynomials. Using Legendre’s orthogonal basis and considering Galerkin’s method, this approach transforms the governing differential equation of a system into algebraic polynomials and then solves the acquired equations which eventually yield the problem solution. In this paper, the LGM method is used to solve the motion equations of single-degree (SDOF) and multi-degree-of-freedom (MDOF) structural systems. The obtained outputs are compared with methods of exact solution (when available), or with the numerical step-by-step linear Newmark-β method. The presented results show that the LGM method offers outstanding accuracy.