The design challenge for large-scale multiprocessors is (1) to minimize communication overhead, (2) allow communication to overlap computation, and (3) coordinate the two without sacrificing processor cost/performance. We show that existing message passing multiprocessors have unnecessarily high communication costs. Research prototypes of message driven machines demonstrate low communication overhead, but poor processor cost/performance. We introduce a simple communication mechanism, Active Messages, show that it is intrinsic to both architectures, allows cost effective use of the hardware, and offers tremendous flexibility. Implementations on nCUBE/2 and CM-5 are described and evaluated using a split-phase shared-memory extension to C, Split-C. We further show that active messages are sufficient to implement the dynamically scheduled languages for which message driven machines were designed. With this mechanism, latency tolerance becomes a programming/compiling concern. Hardware support for active messages is desirable and we outline a range of enhancements to mainstream processors.

Abstract-Wireless power transfer via magnetic resonant coupling is experimentally demonstrated in a system with a large source coil and either one or two small receivers. Resonance between source and load coils is achieved with lumped capacitors terminating the coils. A circuit model is developed to describe the system with a single receiver, and extended to describe the system with two receivers. With parameter values chosen to obtain good fits, the circuit models yield transfer frequency responses that are in good agreement with experimental measurements over a range of frequencies that span the resonance. Resonant frequency splitting is observed experimentally and described theoretically for the multiple receiver system. In the single receiver system at resonance, more than 50% of the power that is supplied by the actual source is delivered to the load. In a multiple receiver system, a means for tracking frequency shifts and continuously retuning the lumped capacitances that terminate each receiver coil so as to maximize efficiency is a key issue for future work.

The continuation of the remarkable exponential increases in processing power over the recent past faces imminent challenges due in part to the physics of deep-submicron CMOS devices and the costs of both chip masks and future fabrication plants. A promising solution to these problems is offered by an alternative to CMOS-based computing, chemically assembled electronic nanotechnology (CAEN).In this paper we outline how CAEN-based computing can become a reality. We briefly describe recent work in CAEN and how CAEN will affect computer architecture. We show how the inherently reconfigurable nature of CAEN devices can be exploited to provide high-density chips with defect tolerance at significantly reduced manufacturing costs. We develop a layered abstract architecture for CAEN-based computing devices and we present preliminary results which indicate that such devices will be competitive with CMOS circuits.

Reconfigurable computing will change the way computing systems are designed, built, and used. PipeRench, a new reconfigurable fabric, combines the flexibility of general-purpose processors with the efficiency of customized hardware to achieve extreme performance speedup.

Future computing workloads will emphasize an architecture's ability to perform relatively simple calculations on massive quantities of mixed-width data. This paper describes a novel reconfigurable fabric architecture, PipeRench, optimized to accelerate these types of computations. PipeRench enables fast, robust compilers, supports forward compatibility, and virtualizes configurations, thus removing the fixed size constraint present in other fabrics. For the first time we explore how the bit-width of processing elements affects performance and show how the PipeRench architecture has been optimized to balance the needs of the compiler against the realities of silicon. Finally, we demonstrate extreme performance speedup on certain computing kernels (up to 190x versus a modern RISC processor), and analyze how this acceleration translates to application speedup.

No abstract

No abstract

This paper describes a computer architecture, Spatial Computation (SC), which is based on the translation of high-level language programs directly into hardware structures. SC program implementations are completely distributed, with no centralized control. SC circuits are optimized for wires at the expense of computation units.In this paper we investigate a particular implementation of SC: ASH (Application-Specific Hardware). Under the assumption that computation is cheaper than communication, ASH replicates computation units to simplify interconnect, building a system which uses very simple, completely dedicated communication channels. As a consequence, communication on the datapath never requires arbitration; the only arbitration required is for accessing memory. ASH relies on very simple hardware primitives, using no associative structures, no multiported register files, no scheduling logic, no broadcast, and no clocks. As a consequence, ASH hardware is fast and extremely power efficient.In this work we demonstrate three features of ASH: (1) that such architectures can be built by automatic compilation of C programs;(2) that distributed computation is in some respects fundamentally different from monolithic superscalar processors; and (3) that ASIC implementations of ASH use three orders of magnitude less energy compared to high-end superscalar processors, while being on average only 33% slower in performance (3.5x worst-case).