Medication and diet could be considered as a risk factor for dental caries and factors such as salivary pH, good oral hygiene could play a protective role for oral health CF children. MIH frequency and lower caries experience seen in CF children could be due to salivary factors or pharmacological treatment they take. The multidisciplinary approach team would be advantageous in the management of children with CF and oral health should be under control during early years of life by paediatric dentists.

The use of LLLT before cavity preparation with laser decreased pain in paediatric dental patients.

The number of endodontists using digital imaging has been increasing in Turkey. The findings of the present study highlighted the need for adapting to new technologies via continuing education.

No abstract

No abstract

This study evaluated the effect of tooth preparation method (diamond bur vs. Er:YAG laser) on the microleakage levels of glass ionomers and resin composite. Human permanent premolars (N = 80) were randomly divided into two groups (n = 40). Cavities on half of the teeth were prepared using diamond bur for enamel and carbide bur for dentin and the other half using Er:YAG laser. The teeth were randomly divided into four groups according to the restoration materials, namely (a) ChemFil Rock (CFR), (b) IonoluxAC (IAC), (c) EQUIA system (EQA) and one resin composite (d) AeliteLS (ALS) (n = 10 per group). Microleakage (m) was assessed at the occlusal and gingival margins after dye penetration (0.5% basic fuchsine for 24 h). On the occlusal aspect, while the cavity preparation types significantly affected the microleakage for CFR (p = 0.015), IAC (p = 0.001) glass ionomer restorations, it did not show significant effect for glass ionomer EQA (p = 0.09) and resin composite ALS (p = 0.2). Er:YAG laser presented less microleakage compared to bur preparation in all groups except for EQA. On the gingival aspect, microleakage decreased significantly for CFR (p = 0.02), IAC (p = 0.001), except for EQA where significant increase was observed (p = 0.001) with the use of Er:YAG laser. Microleakage decrease was not significant at the gingival region between diamond bur and Er:YAG laser for ALS (p = 0.663). At the occlusal and gingival sites in all groups within each preparation method, microleakage level was not significant.

New flowable composites that may be bulk-filled in layers up to 4 mm are indicated as a base beneath posterior composite restorations. Sufficient radiopacity is one of the several important requirements such materials should meet. The aim of this study was to evaluate the radiopacity of bulk-fill flowable composites and to provide a comparison with conventional flowable composites using digital imaging. Ten standard specimens (5 mm in diameter, 1 mm in thickness) were prepared from each of four different bulk-fill flowable composites and nine different conventional flowable composites. Radiographs of the specimens were taken together with 1-mm-thick tooth slices and an aluminum step wedge using a digital imaging system. For the radiographic exposures, a storage phosphor plate and a dental x-ray unit at 70 kVp and 8 mA were used. The object-to-focus distance was 30 cm, and the exposure time was 0.2 seconds. The gray values of the materials were measured using the histogram function of the software available with the system, and radiopacity was calculated as the equivalent thickness of aluminum. The data were analyzed statistically (p<0.05). All of the tested bulk-fill flowable composites showed significantly higher radiopacity values in comparison with those of enamel, dentin, and most of the conventional flowable composites (p<0.05). Venus Bulk Fill (Heraeus Kulzer) provided the highest radiopacity value, whereas Arabesk Flow (Voco) showed the lowest. The order of the radiopacity values for the bulk-fill flowable composites was as follows: Venus Bulk Fill (Heraeus Kulzer) ≥ X-tra Base (Voco) > SDR (Dentsply DeTrey) ≥ Filtek Bulk Fill (3M ESPE). To conclude, the bulk-fill flowable restorative materials, which were tested in this study using digital radiography, met the minimum standard of radiopacity specified by the International Standards Organization.

This study aimed to evaluate the antibacterial and antifungal effects of different disinfection methods for infected root canals with Enterococcus faecalis or Candida albicans in vitro. Material and Methods:Hundred extracted, single-rooted human teeth with straight root canals were selected. After chemomechanical preparation of the root canals, except of those in the negative control group, contamination was performed using Enterococcus faecalis or Candida albicans for 7 days. The infected teeth were divided into three subgroups (n=15) according to the disinfection method applied: photo-activated disinfection, photon-induced photoacoustic streaming and 2.5% sodium hypochlorite irrigation. Microbial samples were collected from the root canals before and after disinfection. A hundred colony forming units were counted, and data were statistically analysed.Results: All experimental groups showed significant reduction of Enterococcus faecalis and Candida albicans. Photon-induced photoacoustic streaming and sodium hypochlorite irrigation had similar antimicrobial effect, which was higher than photo-activated disinfection for both microorganisms (p<0.05). Conclusion:None of the testing methods for root canal disinfection was able to achieve complete elimination of microorganisms. However, the results of this study state that photon-induced photoacoustic streaming, photo-activated disinfection and 2.5% NaOCl has significant antimicrobial effect against Enterococcus faecalis and Candida albicans biofilms in root canals.