The Soultz-sous-Forêts site (Alsace, France) is the first pilot geothermal project in the world that furnished the proof of concept of enhanced geothermal systems by producing energy from a deep-seated granite. The Alsace region, with its hundreds of previous drillings and seismic history related to both oil and potash exploitation, has been shown to have high subterranean temperatures. In the Soultz-sous-Forêts geothermal project, most attention has focused on the basement and the sedimentary cover/basement interface. Thus, the sedimentary portion of the well (approximately 1.4 km thick) has never been fully investigated. The only available data on the Soultzsous-Forêts sedimentary cover are from an old masterlog (GPK-1) with interpretations of the tops and bases of the main geological formations, and from some other less well-documented well logs (EPS-1 and GPK-2). The main challenge of this work is therefore to re-interpret the old well data to provide precise and detailed chronolithostratigraphic logs for GPK-1 and GPK-2, especially in their sedimentary portions. These new investigations of the GPK wells have been possible due to the new data collected in the recent geothermal wells at Rittershoffen (GRT-1 and GRT-2, located 6.5 km from Soultz-sous-Forêts), which are characterized by a quite complete stratigraphic succession. Both sites have been explored by deep drilling operations aiming to exploit the heat extracted from a deep granitic basement (Palaeozoic) covered by a stack of 1.4-and 2.2-km-thick sedimentary rocks (Mesozoic to Cenozoic) at Soultz-sous-Forêts and Rittershoffen, respectively. Thus, the Rittershoffen chrono-lithostratigraphic logs have been used as a baseline to interpret the sedimentary succession in GPK-1 and GPK-2. In conclusion, all the well logs are compared for stratigraphic comparisons. With approximately 1400 m of sedimentary cover at Soultz-sous-Forêts instead of 2200 m at Rittershoffen, the correlation between the two sites showed many differences exist in the sedimentary columns: layers missing due to erosion, lateral thickness variations in formations, and-above all-the occurrence of at least four major fracture zones affecting the units. In addition, a structural analysis was made to more precisely define the limits of the geological formations observed and to present more arguments for the presence of fracture zones or faults.

Between 2012 and 2014, in Rittershoffen, in the Upper Rhine Graben, two geothermal boreholes (GRT-1 and GRT-2) reached the granitic basement at a depth of around 2150 m. The wells crossed about 1160 m of Cenozoic and 1050 m of Mesozoic. In the Cenozoic, these wells crossed the greatest part of the Eocene, the lower part of the Oligocene and a thinner Pliocene. The Quaternary is poorly represented (less than 10 m). In the Mesozoic, the wells crossed the Lower Dogger, the entire Lias and the entire Triassic. A reduced thickness of about 50 m of Upper Permian terminates the sedimentary column before entering into the granitic basement. A major erosional unconformity separates the Middle Jurassic from the Tertiary units (the Upper Jurassic, entire Cretaceous and Paleocene are absent). The Rittershoffen drilled doublets were the subject of particular attention concerning the acquisition of a very precise stratigraphic profile. In this paper, we give the recognition criteria for the fifty-seven formations crossed by the GRT-1 well and their upper and lower boundaries as well as their specific gamma ray signatures. The data are presented in four figures: a general complete log displaying the main sets and three detailed, precise logs showing the sedimentary formations overhanging the granitic basement: the Tertiary, the Jurassic, the Triassic, the Permian and the basement.