The collision energy or collision voltage necessary to obtain 50% fragmentation (characteristic collision energy/voltage, CCE or CCV) has been systematically determined for different types of molecules [poly(ethylene glycols) (PEG), poly(tetrahydrofuran) (PTHF), and peptides] over a wide mass (degrees of freedom) range. In the case of lithium-cationized PEGs a clear linear correlation (R(2) > 0.996) has been found between CCE and precursor ion mass on various instrument types up to 4.5 kDa. A similar linear correlation was observed between CCV and the mass-to-charge ratio. For singly and multiply charged polymers studied under a variety of experimental conditions and on several instruments, all data were plotted together and showed correlation coefficient R(2) = 0.991. A prerequisite to observe such a good linear correlation is that the energy and entropy of activation in a class of polymers is likely to remain constant. When compounds of different structure are compared, the CCV will depend not only on the molecular mass but the activation energy and entropy as well. This finding has both theoretical and practical importance. From a theoretical point of view it suggests fast energy randomization up to at least 4.5 kDa so that statistical rate theories are applicable in this range. These results also suggest an easy method for instrument tuning for high-throughput structural characterization through tandem MS: after a standard compound is measured, the optimum excitation voltage is in a simple proportion with the mass of any structurally similar analyte at constant experimental conditions.

In apricot, detailed analysis of the aromatic profile may represent an efficient tool for classification of genotypes by ripening season, and volatiles with relevant odour contribution may serve as quality markers for selecting towards an extended ripening season of best quality apricots.

IntroductionDiuretic responsiveness in patients with chronic heart failure (CHF) is better assessed by urine production per unit diuretic dose than by the absolute urine output or diuretic dose. Diuretic resistance arises over time when the plateau rate of sodium and water excretion is reached prior to optimal fluid elimination and may be overcome when hypertonic saline solution (HSS) is added to high doses of furosemide.MethodsForty-two consecutively hospitalized patients with refractory CHF were randomized in a 1:1:1 ratio to furosemide doses (125 mg, 250 mg, 500 mg) so that all patients received intravenous furosemide diluted in 150 ml of normal saline (0.9%) in the first step (0–24 h) and the same furosemide dose diluted in 150 ml of HSS (1.4%) in the next step (24–48 h) as to obtain 3 groups as follows: Fourteen patients receiving 125 mg (group 1), fourteen patients receiving 250 mg (group 2), and fourteen patients receiving 500 mg (group 3) of furosemide. Urine samples of all patients were collected at 30, 60, and 90 min, and 3, 4, 5, 6, 8, and 24 h after infusion. Diuresis, sodium excretion, osmolality, and furosemide concentration were evaluated for each urine sample.ResultsAfter randomization, 40 patients completed the study. Two patients, one in group 2 and one in group 3 dropped out. Patients in group 1 (125 mg furosemide) had a mean age of 77 ± 17 years, 43% were male, 6 (43%) had heart failure with a preserved ejection fraction (HFpEF), and 64% were in New York Heart Association (NYHA) class IV; the mean age of patients in group 2 (250 mg furosemide) was 80 ± 8.1 years, 15% were male, 5 (38%) had HFpEF, and 84% were in NYHA class IV; and the mean age of patients in group 3 (500 mg furosemide) was 73 ± 12 years, 54% were male, 6 (46%) had HFpEF, and 69% were in NYHA class IV. HSS added to furosemide increased total urine output, sodium excretion, urinary osmolality, and furosemide urine delivery in all patients and at all time points. The percentage increase was 18,14, and 14% for urine output; 29, 24, and 16% for total sodium excretion; 45, 34, and 20% for urinary osmolarity; and 27, 36, and 32% for total furosemide excretion in groups 1, 2, and 3, respectively. These findings were translated in an improvement in the furosemide dose–response curves in these patients.ConclusionThese results may serve as new pathophysiological basis for HSS use in the treatment of refractory CHF.Electronic supplementary materialThe online version of this article (doi:10.1007/s12325-015-0254-9) contains supplementary material, which is available to authorized users.

The presence of (±)α-pinene, (+)β-pinene, (+)3-carene, and R-(+)limonene terpenes in wastewater of a citrus transformation factory was detected and analyzed, in a previous study, by using Solid Phase Micro-extraction (SPME) followed by GC analyses. Purpose of that research was to compare the genotoxic responses of mixtures of terpenes with the genotoxicity of the individual compounds, and the biological effects of actual wastewater. Genotoxicity was evaluated in the Salmonella reversion assay (Ames test) and in V79 cells by Comet assay. Ames tests indicated that the four single terpenes did not induce an increase of revertants frequency. On the contrary, the mixtures of terpenes caused, in the presence of metabolic activation, a highly significant increase of the revertants in TA100 strain in comparison to the control. The Comet assay showed a significant increase in DNA damage in V79 cells treated for 1h with single or mixed terpenes. Moreover, the actual wastewater was found highly genotoxic in bacterial and mammalian cells. Photocatalytic tests completely photodegraded the pollutants present in aqueous wastewater and the initial high genotoxicity of samples of wastewater collected during the photocatalytic run, was completely lose in 3h of irradiation.

No abstract

In this work, a new sensitive analytical method has been developed and evaluated for the determination of the most commonly used gaseous anesthetics, desflurane, sevoflurane, and this latter's hepatic metabolite hexafluoroisopropanol (HFIP) in the urine. In addition, an evaluation of anesthetics exposition on the urine levels of a small population of surgical operators has been performed and results are briefly discussed.