The electrochemical behavior of the naturally occurring vitamin B(2), riboflavin (Fl(ox)), was examined in detail in dimethyl sulfoxide solutions using variable scan rate cyclic voltammetry (ν = 0.1 - 20 V s(-1)) and has been found to undergo a series of proton-coupled electron transfer reactions. At a scan rate of 0.1 V s(-1), riboflavin is initially reduced by one electron to form the radical anion (Fl(rad)(•-)) at E(0)(f) = -1.22 V versus Fc/Fc(+) (E(0)(f) = formal reduction potential and Fc = ferrocene). Fl(rad)(•-) undergoes a homogeneous proton transfer reaction with the starting material (Fl(ox)) to produce Fl(rad)H(•) and Fl(ox)(-), which are both able to undergo further reduction at the electrode surface to form Fl(red)H(-) (E(0)(f) = -1.05 V vs Fc/Fc(+)) and Fl(rad)(•2-) (E(0)(f) = -1.62 V vs Fc/Fc(+)), respectively. At faster voltammetric scan rates, the homogeneous reaction between Fl(rad)(•-) and Fl(ox) begins to be outrun, which leads to the detection of a voltammetric peak at more negative potentials associated with the one-electron reduction of Fl(rad)(•-) to form Fl(red)(2-) (E(0)(f) = -1.98 V vs Fc/Fc(+)). The variable scan rate voltammetric data were modeled quantitatively using digital simulation techniques based on an interconnecting "scheme of squares" mechanism, which enabled the four formal potentials as well as the equilibrium and rate constants associated with four homogeneous reactions to be determined. Extended time-scale controlled potential electrolysis (t > hours) and spectroscopic (EPR and in situ UV-vis) experiments confirmed that the chemical reactions were completely chemically reversible.

The electrochemical reduction mechanisms of flavin mononucleotide (FMN) in buffered aqueous solutions at pH 3-11 and unbuffered aqueous solutions at pH 2-11 were examined in detail using variable-scan-rate cyclic voltammetry (ν = 0.1-20 V s(-1)), controlled-potential bulk electrolysis, UV-vis spectroscopy, and rotating-disk-electrode voltammetry. In buffered solutions at pH 3-5, FMN undergoes a two-electron/two-proton (2e(-)/2H(+)) reduction to form FMNH2 at all scan rates. When the buffered pH is increased to 7-9, FMN undergoes a 2e(-) reduction to form FMN(2-), which initially undergoes hydrogen bonding with water molecules, followed by protonation to form FMNH(-). At a low voltammetric scan rate of 0.1 V s(-1), the protonation reaction has sufficient time to take place. However, at a higher scan rate of 20 V s(-1), the proton-transfer reaction is outrun, and upon reversal of the scan direction, less of the FMNH(-) is available for oxidation, causing its oxidation peak to decrease in magnitude. In unbuffered aqueous solutions, three major voltammetric waves were observed in different pH ranges. At low pH in unbuffered solutions, where [H(+)] ≥ [FMN], (FMN)H(-) undergoes a 2e(-)/2H(+) reduction to form (FMNH2)H(-) (wave 1), similar to the mechanism in buffered aqueous solutions at low pH. At midrange pH values (unbuffered), where pH ≤ pKa of the phosphate group and [FMN] ≥ [H(+)], (FMN)H(-) undergoes a 2e(-) reduction to form (FMN(2-))H(-) (wave 2), similar to the mechanism in buffered aqueous solutions at high pH. At high pH (unbuffered), where pH ≥ pKa = 6.2 of the phosphate group, the phosphate group loses its second proton to be fully deprotonated, forming (FMN)(2-), and this species undergoes a 2e(-) reduction to form (FMN(2-))(2-) (wave 3).

The electrochemical reduction mechanisms of 2 synthesized flavins (Flox) were examined in detail in deoxygenated solutions of DMSO containing varying amounts of water, utilizing variable scan rate cyclic voltammetry (ν = 0.1-20 V s(-1)), controlled-potential bulk electrolysis, and UV-vis spectroscopy. Flavin 1, which contains a hydrogen atom at N(3), is capable of donating its proton to other reduced flavin species. After 1e(-) reduction, the initially formed Fl(•-) receives a proton from another Flox to form FlH(•) (and concomitantly produce the deprotonated flavin, Fl(-)), although the equilibrium constant for this process favors the back reaction. Any FlH(•) formed at the electrode surface immediately undergoes another 1e(-) reduction to form FlH(-), which reacts with Fl(-) to form 2 molecules of Fl(•-). Further 1e(-) reduction of Fl(•-) at more negative potentials produces the dianion, Fl(2-), which can also be protonated by another Flox to form FlH(-) and Fl(-). Flavin 2, which is methylated at N(3) (and therefore has no acidic proton), undergoes a simple chemically reversible 1e(-) reduction process in DMSO provided the water content is low (<100 mM). Further 1e(-) reduction of Fl(•-) (from flavin 2) at more negative potentials leads to the dianion, Fl(2-), which is protonated by trace water in solution to form FlH(-), similar to the mechanism of flavin 1 at high scan rates. Addition of sufficient amounts of water to nonaqueous solvents results in protonation of the anion radical species, Fl(•-), for both flavins, causing an increase in the amount of FlH(-) in solution. This behavior contrasts with what is observed for quinones, which are also reduced in two 1e(-) steps in aprotic organic solvents to form the radical anions and dianions, but are able to exist in hydrogen-bonded forms (with trace or added water) without undergoing protonation.

Hole transfer dynamics of Atto647N sensitized p-type NiO nanoparticle (NP) thin films is investigated using both ensemble-averaged and single-molecule spectroscopy techniques. The rate of hole transfer is dependent on the processing conditions and is enhanced when the NiO is pre-annealed in air as compared to vacuum. This is possibly due to an upward shift of the valence band of the semiconductor and an increase in the free energy for hole transfer as more Ni(2)O(3) are formed in the presence of air. The stretched exponential fluorescence decay profile of Atto647N on NiO NP suggests the presence of a distribution of hole transfer rates. This is in agreement with the observed emission lifetime and intensity fluctuations and non-monoexponential fluorescence decays for individual Atto647N molecules on NiO NP films. A plausible explanation for the heterogeneous hole transfer rates is an inhomogeneous distribution of (defect) sites on the metal oxide due to the processing conditions and a fluctuation in the intermolecular interaction.

A new molecular dyad consisting of a Cy5 chromophore and ferrocene (Fc) and a triad consisting of Cy5, Fc, and β-cyclodextrin (CD) are synthesized and their photophysical properties investigated at both the ensemble and single-molecule levels. Hole transfer efficiency from Cy5 to Fc in the dyad is reduced upon addition of CD. This is due to an increase in the Cy5-Fc separation (r) when the Fc is encapsulated in the macrocyclic host. On the other hand, the triad adopts either a Fc-CD inclusion complex conformation in which hole transfer quenching of the Cy5 by Fc is minimal or a quasi-static conformation with short r and rapid charge transfer. Single-molecule fluorescence measurements reveal that r is lengthened when the triad molecules are deposited on a glass substrate. By combining intramolecular charge transfer and competitive supramolecular interaction, the triad acts as an efficient chemical sensor to detect different bioactive analytes such as amantadine hydrochloride and sodium lithocholate in aqueous solution and synthetic urine.