Abstract. In this paper we prove the existence of mild solutions for a nonlocal problem governed by an abstract semilinear non-autonomous second order differential inclusion, where the non-linear part is an upper-Caratheodory semicontinuous multimap. Our existence theorem is obtained thanks to the introduction of a fundamental Cauchy operator. Finally we apply our main result to provide the controllability of a problem involving a non-autonomous wave equation.Mathematics Subject Classification (2010): 34A60, 34G25.
Advanced materials, especially carbon fiber reinforced composites (CFRP), have gained the attention of different industries whichproduce lightweight and high-performance components. The most used manufacturing processes to realize these kinds of products are Resin Transfer Molding (RTM) and vacuum bag molding with autoclave curing. RTM is based on dry fiber technology and it appears the most promising manufacturing process to realized high-quality carbon fiber parts reducing cost and manufacturing time, especially if high pressure variants are employed. On the other hand, vacuum bag molding with autoclave curing is a very consolidated process which is, however, associated with long manufacturing time and costs as well as to low repeatability of the process due to the high labor input. Out-of-autoclave methods, such as pressure bag molding (PBM) have been developed to overcome the issues of vacuum bag molding process. From the environmental point of view, the manufacturing of CFRP components is associated with high environmental loads due to the impacts related to both raw materials and manufacturing processes. For this reason, reducing the energy consumption of production phases can lead to the development of greener CFRP products. In this context, the main scope of the present research is to evaluate and compare the environmental loads of a component for the automotive industry realized exploiting the RTM, the PBM and the bag molding processes to determine which one is eco-friendlier. This analysis has been conducted following the standard Life Cycle Assessment methodology based on a “cradle to gate” approach. In this way, the use phase and the disposal of the CFRP component have not been included in the analysis. Results have been evaluated by comparing the equivalent CO2 related to each manufacturing process.
Scanning microwave microscopy (SMM) is a novel metrological tool that advances the quantitative, nanometric, high-frequency, electrical characterization of a broad range of materials of technological importance. In this work, we report an inverted near-field scanning microwave microscopy (iSMM) investigation of a graphene oxide-based epoxy nanocomposite material at a nanoscopic level. The high-resolution spatial mapping of local conductance provides a quantitative analysis of the sample’s electrical properties. In particular, the electrical conductivity in the order of ∼10−1 S/m as well as the mapping of the dielectric constant with a value of ∼4.7 ± 0.2 are reported and validated by the full-wave electromagnetic modeling of the tip–sample interaction.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.