The gingerols and shogaols derived from ginger have excellent antibacterial properties against oral bacteria. However, some researchers have noted their dose-dependent potential toxicity. The aim of this study was to enhance the biofunctionality and biocompatibility of the application of ginger to dental titanium screws. To increase the amount of coating of the n-hexane-fractionated ginger on the titanium surface and to control its release, ginger was loaded in different concentrations in a photo-crosslinkable GelMA hydrogel. To improve coating stability of the ginger hydrogel (GH), the wettability of the surface was modified by pre-calcification (TNC), then GH was applied on the surface. As a result, the ginger fraction, with a high content of phenolic compounds, was effective in the inhibition of the growth of S. mutans and P. gingivalis. The GH slowly released the main compounds of ginger and showed excellent antibacterial effects with the concentration. Although bone regeneration was slightly reduced with the ginger-loading concentration due to the increased contents of polyphenolic compounds, it was strongly supplemented through the promotion of osteosis formation by the hydrogel and TNC coating. Finally, we proved the biosafety and superior biofunctionalities the GH−TNC coating on a Ti implant. However, it is recommended to use an appropriate concentration, because an excessive concentration of ginger may affect the improved biocompatibility in clinical applications.

Magnesium (Mg), as a biodegradable material, is a promising candidate for orthopedic surgery. Long-bone fractures usually occur in cancellous-bone-rich epiphysis at each end or the cortical-rich diaphysis in the center, with different bone healing processes. Little is known about the differences in results between the two regions when applying Mg implants. Therefore, this study aimed to compare the biodegradation and osteogenesis of Mg implants in a rat model’s epiphysis and diaphysis of the long bone. Twelve male Sprague Dawley rats underwent Mg rod implantation in the distal femoral epiphyses and tibial diaphyses. Every three weeks for up to twelve weeks, degradation behavior, gas evolution, and new bone formation were measured by micro CT. Histomorphology was analyzed by Hematoxylin and Eosin, Villanueva bone staining, and TRAP staining for osteoclastogenesis evaluations. Micro-CT analysis showed statistically significant higher new bone formation in the epiphysis group than in the diaphysis group, which correlated with a lower gas volume. Histological analysis showed higher osseointegration of Mg implants in the epiphyseal region than in the diaphyseal region. The magnesium implant’s osteoclastogenesis-inhibiting properties were shown in the surrounding areas in both the cortical bone of the diaphysis and the cancellous bone of the epiphysis. Our findings show the differences in the magnesium implant’s osteogenesis and biodegradation in the epiphysis and the diaphysis. These dissimilarities indicate a better response of the epiphyseal region to the Mg implants, a promising biomaterial for orthopedic surgery applications.