Imaging spectroscopy, also known as hyperspectral remote sensing, is based on the characterization of Earth surface materials and processes through spectrally-resolved measurements of the light interacting with matter. The potential of imaging spectroscopy for Earth remote sensing has been demonstrated since the 1980s. However, most of the developments and applications in imaging spectroscopy have largely relied on airborne spectrometers, as the amount and quality of space-based imaging spectroscopy data remain relatively low to date. The upcoming Environmental Mapping and Analysis Program (EnMAP) German imaging spectroscopy mission is intended to fill this gap. An overview of the main characteristics and current status of the mission is provided in this contribution. The core payload of EnMAP consists of a dual-spectrometer instrument measuring in the optical spectral range between 420 and 2450 nm with a spectral sampling distance varying between 5 and 12 nm and a reference signal-to-noise ratio of 400:1 in the visible and near-infrared and 180:1 in the shortwave-infrared parts of the spectrum. EnMAP images will cover a 30 km-wide area in the across-track direction with a ground sampling distance of 30 m. An across-track tilted observation capability will enable a target revisit time of up to four days at the Equator and better at high latitudes. EnMAP will contribute to the development and exploitation of spaceborne imaging spectroscopy applications by making high-quality data freely available to scientific users worldwide.

Aims. This paper addresses the global molecular gas properties of a representative sample of galaxies hosting low-luminosity quasistellar objects. An abundant supply of gas is necessary to fuel both the active galactic nucleus and any circum-nuclear starburst activity of QSOs. The connection between ultraluminous infrared galaxies and the host properties of QSOs is still subject to a controversial debate. Nearby low-luminosity QSOs are ideally suited to study the properties of their host galaxies because of their higher frequency of occurrence compared to high-luminosity QSOs in the same comoving volume and because of their small cosmological distance. Methods. We selected a sample of nearby low-luminosity QSO host galaxies that is free of infrared excess biases. All objects are drawn from the Hamburg-ESO survey for bright UV-excess QSOs, have δ > −30• and redshifts that do not exceed z = 0.06. The IRAM 30 m telescope was used to measure the 12 CO(1−0) and 12 CO(2−1) transition in parallel. Results. 27 out of 39 galaxies in the sample have been detected. The molecular gas masses of the detected sources range from 0.4 × 10 9 M to 9.7 × 10 9 M . The upper limits of the non-detected sources correspond to molecular gas masses between 0.3 × 10 9 M and 1.2 × 10 9 M . We can confirm that the majority of galaxies hosting low-luminosity QSOs are rich in molecular gas. The properties of galaxies hosting brighter type I AGN and circumnuclear starformation regions differ from the properties of galaxies with fainter central regions. The overall supply of molecular gas and the spread of the line width distribution is larger. When comparing the farinfrared with the CO luminosities, the distribution can be separated into two different power-laws: one describing the lower activity Seyfert I population and the second describing the luminous QSO population. The separation in the L FIR /L CO behavior may be explainable with differing degrees of compactness of the emission regions. We provide a simple model to describe the two power-laws. The sample studied in this paper is located in a transition region between the two populations.

Recognizing the properties of the host galaxies of quasi-stellar objects (QSOs) is essential for understanding the suspected coevolution of central supermassive black holes (BHs) and their host galaxies. Low-luminosity type-1 QSOs (LLQSOs) are ideal targets because of their small cosmological distance, which allows for a detailed structural analysis. We selected a subsample of the Hamburg/ESO survey for bright UV-excess QSOs that contains only the 99 nearest QSOs with redshift z ≤ 0.06. From this LLQSO sample, we observed 20 galaxies and performed aperture photometry and bulge-disk-decomposition with BUDDA on near-infrared J-, H-, and K-band images to separate disk, bulge, bar, and nuclear component. From the photometric decomposition of these 20 objects and visual inspection of images of another 26, we find that ∼50% of the hosts are disk galaxies and most of them (86%) are barred. Stellar masses, calculated from parametric models based on inactive galaxy colors, range from 2 × 10 9 M to 2 × 10 11 M with an average mass of 7 × 10 10 M . Black hole masses measured from single-epoch spectroscopy range from 1 × 10 6 M to 5 × 10 8 M with a median mass of 3 × 10 7 M . In comparison with higher-luminosity QSO samples, LLQSOs tend to have lower stellar and BH masses. Moreover, in the effective radius vs. mean surface-brightness projection of the fundamental plane, they lie in the transition area between luminous QSOs and normal galaxies. This can be seen as additional evidence that they populate a region intermediate between the local Seyfert population and luminous QSOs at higher redshift. This region has not been well studied so far. Eleven LLQSOs, for which we have reliable morphological decompositions and BH mass estimations, lie below the published BH mass vs. bulge luminosity relations for inactive galaxies. This can partially be explained if one assumes that the bulges of active galaxies contain much younger stellar populations than the bulges of inactive galaxies. Another possibility would be that their BHs are undermassive. This might indicate that the growth of the host spheroid precedes that of the BH.

The Low Resolution Spectrometer of the MIRI, which forms part of the imager module, will provide R∼100 long-slit and slitless spectroscopy from 5 to 12 µm. The design is optimised for observations of compact sources, such as exoplanet host stars. We provide here an overview of the design of the LRS, and its performance as measured -2during extensive test campaigns, examining in particular the delivered image quality, dispersion, and resolving power, as well as spectrophotometric performance, flatfield accuracy and the effects of fringing. We describe the operational concept of the slitless mode, which is optimally suited to transit spectroscopy of exoplanet atmospheres. The LRS mode of the MIRI was found to perform consistently with its requirements and goals.

We report ab initio calculations for neutron drops in a 10 MeV external harmonic-oscillator trap using chiral nucleon-nucleon plus three-nucleon interactions. We present total binding energies, internal energies, radii and odd-even energy differences for neutron numbers N = 2-18 using the no-core shell model with and without importance truncation. Furthermore, we present total binding energies for N = 8, 16, 20, 28, 40, 50 obtained in a coupled-cluster approach. Comparisons with quantum Monte Carlo results, where available, using Argonne v 8 with three-nucleon interactions reveal important dependences on the chosen Hamiltonian.

No abstract

Natural materials often exhibit excellent mechanical properties. An example of outstanding impact resistance is the pummelo fruit (Citrus maxima) which can drop from heights of 10 m and more without showing significant outer damage. Our data suggest that this impact resistance is due to the hierarchical organization of the fruit peel, called pericarp. The project presented in the current paper aims at transferring structural features from the pummelo pericarp to engineering materials, in our case metal foams, produced by the investment casting process. The transfer necessitates a detailed structural and mechanical analysis of the biological model on the one hand, and the identification and development of adequate materials and processes on the other hand. Based on this analysis, engineering composite foam structures are developed and processed which show enhanced damping and impact properties. The modified investment casting process and the model alloy Bi57Sn43 proved to be excellent candidates to make these bio‐inspired structures. Mechanical testing of both the natural and the engineering structures has to consider the necessity to evaluate the impact of the different hierarchical features. Therefore, specimens of largely varying sizes have to be tested and size effects cannot be ignored, especially as the engineering structures might be upscaled in comparison with the natural role model. All in all, the present results are very promising: the basis for a transfer of bio‐inspired structural hierarchical levels has been set.

No abstract