Distributed Electric Propulsion (DEP) technology uses multiple propulsors driven by electric motors distributed about the airframe to yield beneficial aerodynamic-propulsioninteraction. The NASA SCEPTOR flight demonstration project will retrofit an existing internal combustion engine-powered light aircraft with two types of DEP: small "high-lift" propellers distributed along the leading edge of the wing which accelerate the flow over the wing at low speeds, and larger cruise propellers located at each wingtip for primary propulsive power. The updated high-lift system enables a 2.5x reduction in wing area as compared to the original aircraft, reducing drag at cruise and shifting the velocity for maximum lift-to-drag ratio to a higher speed, while maintaining low-speed performance. The wingtip-mounted cruise propellers interact with the wingtip vortex, enabling a further efficiency increase that can reduce propulsive power by 10%. A tradespace exploration approach is developed that enables rapid identification of salient trades, and subsequent creation of SCEPTOR demonstrator geometries. These candidates were scrutinized by subject matter experts to identify design preferences that were not modeled during configuration exploration. This exploration and design approach is used to create an aircraft that consumes an estimated 4.8x less energy at the selected cruise point when compared to the original aircraft. Nomenclature = coefficient of drag 0 = coefficient of drag at zero lift = coefficient of lift = maximum coefficient of lift ⁄ = ratio of drag to dynamic pressure = battery specific energy = energy use per unit distance, conventional configuration = energy use per unit distance, distributed electric propulsion configuration = aircraft gross weight ℎ = altitude above mean sea level = induced drag constant ⁄ = ratio of lift to drag ( ⁄ ) = maximum ratio of lift to drag = mass of battery pack = power consumption of aircraft at cruise = specific excess power (instantaneous rate of climb capability) = rate of descent = range parameter at cruise power, no reserves = efficiency multiplier = velocity at cruise 0 = stall speed in the landing configuration , ∞ = airspeed velocity
Abstract-This paper describes the power and command system architecture of the X-57 Maxwell flight demonstrator aircraft. The X-57 is an experimental aircraft designed to demonstrate radically improved aircraft efficiency with a 3.5 times aero-propulsive efficiency gain at a "high-speed cruise" flight condition for comparable general aviation aircraft. These gains are enabled by integrating the design of a new, optimized wing and a new electric propulsion system. As a result, the X-57 vehicle takes advantage of the new capabilities afforded by electric motors as primary propulsors. Integrating new technologies into critical systems in experimental aircraft poses unique challenges that require careful design considerations across the entire vehicle system, such as qualification of new propulsors (motors, in the case of the X-57 aircraft), compatibility of existing systems with a new electric power distribution bus, and instrumentation and monitoring of newly qualified propulsion system devices.Keywords-aircraft propulsion and power, electric propulsion, experimental aircraft, failure modes and effects analysis, x-plane
The rise of electric propulsion systems has pushed aircraft designers towards new and potentially transformative concepts. As part of this effort, NASA is leading the SCEPTOR program which aims at designing a fully electric distributed propulsion general aviation aircraft. This article highlights critical aspects of the design of SCEPTOR's propulsion system conceived at Joby Aviation in partnership with NASA, including motor electromagnetic design and optimization as well as cooling system integration. The motor is designed with a finite element based multi-objective optimization approach. This provides insight into important design tradeoffs such as mass versus efficiency, and enables a detailed quantitative comparison between different motor topologies. Secondly, a complete design and Computational Fluid Dynamics analysis of the air breathing cooling system is presented. The cooling system is fully integrated into the nacelle, contains little to no moving parts and only incurs a small drag penalty. Several concepts are considered and compared over a range of operating conditions. The study presents trade-offs between various parameters such as cooling efficiency, drag, mechanical simplicity and robustness. Nomenclature
Purpose This paper aims to review national aeronautics and space administration (NASA’s) broad investments in electrified aircraft propulsion (EAP). NASA investments are guided by an assessment of potential market impacts, technical key performance parameters, and technology readiness attained through a combination of studies, enabling fundamental research and flight research. Design/methodology/approach The impact of EAP varies by market and NASA is considering three markets as follows: national/international, on-demand mobility and short-haul regional air transport. Technical advances in key areas have been made that indicate EAP is a viable technology. Flight research is underway to demonstrate integrated solutions and inform standards and certification processes. Findings A key finding is that sufficient technical advances in key areas have been made, which indicate EAP is a viable technology for aircraft. Significant progress has been made to reduce EAP adoption barriers and further work is needed to transition the technology to a commercial product and improve the technology, so it is applicable to large transonic aircraft. Practical implications Significant progress has been made to reduce EAP adoption barriers and further work is needed to transition the technology to a commercial product and improve the technology, so it is applicable to large transonic aircraft. Originality/value This paper will review the activities of the hybrid gas-electric subproject of the Advanced Air Transport Technology Project, the Revolutionary Vertical Lift Technology Project and the X-57 Flight Demonstration Project, and discuss the potential EAP benefits for commercial and military applications. This paper focuses on the vehicle-related activities, however, there are related NASA activities in air space management and vehicle autonomy activities, as well as a breakthrough technology project called the Convergent Aeronautics Solutions Project. The target audience is people interested in EAP.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.