This work investigates the relationship among the processing, morphology, and the mechanical properties of injection‐molded poly(L‐lactic acid) (PLLA). Melt processing temperature, mold temperature, injection flow rate, and holding pressure were systematically changed following a design of experiments array. The thermomechanical environment imposed during processing was estimated by computer simulations for the mold‐filling phase, which allows the calculation of shear stress, shear rate, and the thickness of frozen skin layer. The morphology was characterized by differential scanning calorimetry and hot recoverable strain measurements. The analysis of variance results of influence of processing factors on the morphology are in good agreement with the analysis of thermomechanical parameters on the morphology. The primary factor for inducing the crystallinity in PLLA product was the stress‐induced crystallization, whereas the thermal induced crystallization had a little effect. The morphology–mechanical property relationships were established. The crystallinity developed during processing has little effect on elastic modulus, increases the yield strength, and severely decreases the elongation at break. The level of molecular orientation developed during processing has little effect on elastic modulus, but increases both the yield strength and the elongation at break. POLYM. ENG. SCI., 47:1141–1147, 2007. © 2007 Society of Plastics Engineers

One of the most widely used fabrication methods of three dimensional porous scaffolds involves compression moulding of a polymer salt mixture, followed by salt leaching. However, the scaffolds prepared by this technique have typically limited interconnectivity. In this study, besides salt particles, an additional polymeric porogen, poly(ethylene oxide), PEO, was added to poly(L-lactic acid), PLLA, to enhance the interconnectivity of the scaffolds. Compression moulded specimens were quenched and put into water, where PEO crystallized and phase separated. Following the leaching of PEO fraction, the permeability and interconnectivity among the macropores formed by salt leaching could be observed. The porosities obtained in the prepared scaffolds were between 76 to 86%. Moreover, the highest porosity of 86% was obtained with minimum fraction of total porogen. The water absorption of the porous scaffolds prepared with PEO could vary between 280 to 450% while water uptake of pure PLLA scaffolds was about 93%. The increase of interconnectivity induced by compounding PLLA with PEO could also be obtained in porous PLLA/starch blends and PLLA/hydroxyapatite composites demonstrating the versatility and wide applicability of this preparation protocol. The simplicity of this organic solvent free preparation procedure of three-dimensional porous scaffolds with high interconnectivity and high surface area to volume ratio holds a promise for several tissue engineering applications.

The three-dimensional scaffolds of a blend of starch and poly(L-lactic) acid, SPLA70, were produced using compression molding of polymer/salt mixture followed by leaching of salt. One series of scaffolds were prepared with varying polymer-to-salt ratio while keeping the salt size constant, and the other series of scaffolds were prepared with varying salt sizes while keeping the polymer-to-salt ratio constant. The X-ray microcomputed tomography and scanning electron microscopy assay were used to analyze the porous morphologies, porosity and distribution of porosity of the porous scaffolds. Salt-free and integrated SPLA70 scaffolds with porosities ranging from 74% to 82% and pore sizes of 125-250 to 500-1000 microm can be fabricated using the present fabrication technique. The water uptake of the SPLA70 scaffolds increases with increasing porosities and also with increasing pore size. In dry state, the storage modulus decreases with increasing porosity and also with increasing pore size. The normalized modulus values are related to normalized density of the scaffolds by a power-law function with an exponent between 2 and 3. For the immersed scaffolds under physiological conditions, the storage modulus was less dependent on porosity and pore size. However, the loss factor increased significantly compared with dry state measurements. The present study clearly shows that the mechanical performance of porous polymeric constructs in dry and in immersed state is completely different, and for comparison with biomechanical performance of tissues, the tests should ideally be performed in immersed state.

No abstract