No abstract

No abstract

No abstract

Synthesis of mesoporous carbon from merbau sawdust with H2O2 as activator using reflux method followed by carbonization at 800 °C (RC800) had been carried out. This research is aiming to produce effective pathway to synthesize effective nickel-mesoporous carbon catalyst. The nickel metal was impregnated on the mesoporous carbon by wet impregnation using the salt precursor of Ni(NO3)2∙6H2O. The results showed that carbon RC800 and C800 had a specific surface area of 135.18 and 182.48 m2/g. Specific surface area of Ni/RC800 and Ni/C800 catalyst were 41.31 and 7.15 m2/g, respectively. The metal content in Ni/RC800 and Ni/C800 catalyst were 0.83 and 0.92 wt%, respectively. Ni/RC800 catalyst had the highest acidity (7.64 mmol/g) compared to Ni/C800 catalyst (6.99 mmol/g), RC800 (97.43 mmol/g), and C800 (6.17 mmol/g). The Ni/RC800 catalyst has the highest activity with the liquid product conversion of 66.01 wt%. Its selectivity towards gasoline fraction, diesel fraction, alcohol, and organic was 8.06, 1.17, 2.61, and 54.13%, respectively. Copyright © 2022 by Authors, Published by BCREC Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).

The problem of sulfur content in heavy oil is a challenge for researchers to meet the needs of environmentally friendly fuels. The catalyst preparation plays an important role in the desulfurization process. The synthesis of ZnO-activated carbon as a catalyst and its activity in oxidative desulfurization (ODS) reaction has been successfully carried out. In this work, the ZnO and activated carbon (AC) were blended by a solid-solid reaction. The ZnO, AC, and ZnO-AC were then characterized using acidity test with pyridine vapor adsorption, Fourier Transform Infra-Red (FTIR), X-ray Diffraction (XRD), Scanning Electron Microscope-Energy Dispersive X-Ray (SEM-EDX), and Surface Area Analyzer (SAA). ODS of dibenzothiophene (DBT) reaction was performed by using H2O2 under variation of the reaction time (30, 60, 120, and 150 min) for the ZnO-AC catalyst. The efficiency of ODS-DBT was analyzed by a UV-Visible spectrophotometer. The XRD analysis result showed that ZnO-AC blended displays new crystal peaks of Zn in the AC diffractogram. The surface area (734.351 m2/g) and acidity (4.8780 mmol/g) of ZnO-AC were higher than ZnO and AC themselves. ZnO-AC produced the highest efficiency of ODS-DBT which was 93.83% in the reaction time of 120 min. Therefore, the simple procedure of this physical blending was proved effective to homogenize between ZnO and AC into ZnO-AC so that it has good physicochemical properties as an ODS-DBT catalyst. Copyright © 2021 by Authors, Published by BCREC Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).