Deformation of metals and alloys by dislocations gliding between well-separated slip planes is a well-understood process, but most crystal structures do not possess such simple geometric arrangements. Examples are the Laves phases, the most common class of intermetallic compounds and exist with ordered cubic, hexagonal, and rhombohedral structures. These compounds are usually brittle at low temperatures, and transformation from one structure to another is slow. On the basis of geometric and energetic considerations, a dislocation-based mechanism consisting of two shears in different directions on adjacent atomic planes has been used to explain both deformation and phase transformations in this class of materials. We report direct observations made by Z-contrast atomic resolution microscopy of stacking faults and dislocation cores in the Laves phase Cr2Hf. These results show that this complex dislocation scheme does indeed operate in this material. Knowledge gained of the dislocation core structure will enable improved understanding of deformation mechanisms and phase transformation kinetics in this and other complex structures.

No abstract

No abstract

No abstract

The influence of strain on catalytic activity has previously been examined directly by calculations and indirectly by experiments. The origin of the phenomenon has been attributed to strain-induced changes in the catalyst electronic structure. By employing a Pd-based metallic glass film capable of large elastic strains, we provide direct experimental evidence for catalytic activity being differently influenced by mechanically applied uniaxial tensile and compressive strains. We demonstrate the effect on the oxygen reduction reaction with cyclic voltammetry (CV) curves at different strain levels and compare X-ray photoelectron spectrometry (XPS) results for unstrained and strained (in uniaxial tension) specimens to confirm valence electron band shifts. The experimental findings are complemented by electronic structure calculations on single crystal Pd, as well as alloys with Cu and Si. The CV and XPS shifts observed in the experiments are consistent in both direction and magnitude to those predicted by theory for single crystal Pd.

No abstract

a b s t r a c tThe micromechanics of plastic deformation and phase transformation in a three-phase advanced high strength steel are analyzed both experimentally and by microstructurebased simulations. The steel examined is a three-phase (ferrite, martensite and retained austenite) quenched and partitioned sheet steel with a tensile strength of $ 980 MPa. The macroscopic flow behavior and the volume fraction of martensite resulting from the austenite-martensite transformation during deformation were measured. In addition, micropillar compression specimens were extracted from the individual ferrite grains and the martensite particles, and using a flat-punch nanoindenter, stress-strain curves were obtained. Finite element simulations idealize the microstructure as a composite that contains ferrite, martensite and retained austenite. All three phases are discretely modeled using appropriate crystal plasticity based constitutive relations. Material parameters for ferrite and martensite are determined by fitting numerical predictions to the micropillar data. The constitutive relation for retained austenite takes into account contributions to the strain rate from the austenite-martensite transformation, as well as slip in both the untransformed austenite and product martensite. Parameters for the retained austenite are then determined by fitting the predicted flow stress and transformed austenite volume fraction in a 3D microstructure to experimental measurements. Simulations are used to probe the role of the retained austenite in controlling the strain hardening behavior as well as internal stress and strain distributions in the microstructure.

No abstract