The remarkable performance of hybrid perovskite photovoltaics is attributed to their long carrier lifetimes and high photoluminescence (PL) efficiencies. High-quality films are associated with slower PL decays, and it has been claimed that grain boundaries have a negligible impact on performance. We used confocal fluorescence microscopy correlated with scanning electron microscopy to spatially resolve the PL decay dynamics from films of nonstoichiometric organic-inorganic perovskites, CH3NH3PbI3(Cl). The PL intensities and lifetimes varied between different grains in the same film, even for films that exhibited long bulk lifetimes. The grain boundaries were dimmer and exhibited faster nonradiative decay. Energy-dispersive x-ray spectroscopy showed a positive correlation between chlorine concentration and regions of brighter PL, whereas PL imaging revealed that chemical treatment with pyridine could activate previously dark grains.

Passive grain boundaries (GBs) are essential for polycrystalline solar cells to reach high efficiency. However, the GBs in Cu2ZnSn(S,Se)4 have less favorable defect chemistry compared to CuInGaSe2. Here, using scanning probe microscopy we show that lithium doping of Cu2ZnSn(S,Se)4 changes the polarity of the electric field at the GB such that minority carrier electrons are repelled from the GB. Solar cells with lithium-doping show improved performance and yield a new efficiency record of 11.8% for hydrazine-free solution-processed Cu2ZnSn(S,Se)4. We propose that lithium competes for copper vacancies (forming benign isoelectronic LiCu defects) decreasing the concentration of ZnCu donors and competes for zinc vacancies (forming a LiZn acceptor that is likely shallower than CuZn). Both phenomena may explain the order of magnitude increase in conductivity. Further, the effects of lithium doping reported here establish that extrinsic species are able to alter the nanoscale electric fields near the GBs in Cu2ZnSn(S,Se)4. This will be essential for this low-cost Earth abundant element semiconductor to achieve efficiencies that compete with CuInGaSe2 and CdTe.

We study the photoinduced degradation of hybrid organometal perovskite photovoltaics under illumination and ambient atmosphere using UV-vis absorption, atomic force microscopy, and device performance. We correlate the structural changes in the surface of the perovskite film with changes in the optical and electronic properties of the devices. The photodecomposition of the methylammonium lead triiodide perovskite layer itself proceeds much more slowly than the photodegradation of the performance of devices with fullerene/bathocuproine/aluminum top contacts, indicating that the active layer is more stable than the interface with the electrodes in this geometry. The evolution of the perovskite active layer performance proceeded through several phases: (1) an initial improvement in device characteristics, (2) a plateau with very slow degradation and finally (3) a catastrophic decline in material performance accompanied by marked changes in film morphology. The rapid increase in surface roughness of the active perovskite semiconductor associated with sudden failure also correlates with decreased absorption at the perovskite band edge and growth of a lead iodide absorption feature. We find that degradation requires both light and moisture, is accelerated at increased humidity, and scales linearly with light intensity, depending primarily on total photon dose.