Miniaturized biochemical devices in glass, silicon and polymer materials are starting to find their way from the academic laboratories to real-life applications. However, most attention has been given to miniaturize the downstream functions of various microfluidic systems, leaving the sample introduction and preparation steps to more conventional, bulkier solutions. For point-of-care diagnostics in particular, it becomes crucial to be able to handle complex human samples in a miniaturized format.In this work, we report on a microsystem for on-chip sample preparation that is able to remove blood cells from whole blood. The hybrid system consists of a commercially available membrane filter incorporated into a poly(dimethylsiloxane) (PDMS) casted device. Membrane materials were evaluated on the bases of low nonspecific adsorption of free and protein-bound testosterone as analyte substance. The hybrid system including a hydrophilic polypropylene filter successfully removed blood cells from diluted human whole blood. Surface oxidation was sufficient to make the plasma filtrate flow through the membrane filter and the channel system by capillary force alone and thus no external pumping source was needed.

A novel microsystem device in poly(dimethylsiloxane) (PDMS) for MS detection is presented. The microchip integrates sample injection, capillary electrophoretic separation, and electrospray emitter in a single substrate, and all modules are fabricated in the PDMS bulk material. The injection and separation flow is driven electrokinetically and the total amount of external equipment needed consists of a three-channel high-voltage power supply. The instant switching between sample injection and separation is performed through a series of low-cost relays, limiting the separation field strength to a maximum of 270 V/cm. We show that this set-up is sufficient to accomplish electrospray MS analysis and, to a moderate extent, microchip separation of standard peptides. A new method of instant in-channel oxidation makes it possible to overcome the problem of irreversibly bonded PDMS channels that have recovered their hydrophobic properties over time. The fast method turns the channel surfaces hydrophilic and less prone to nonspecific analyte adsorption, yielding better separation efficiencies and higher apparent peptide mobilities.

An acoustic microfluidic system for miniaturized fluorescence activated cell sorting (µ FACS) is presented.

An acoustic mixer for glass channel microfluidic systems is presented. An acoustic standing wave, perpendicular to the fluid flow, is generated by the excitation of a miniaturized piezoelectric transducer operated around 10 MHz. The transducer is fabricated into a planar printed circuit board structure, constituting the bottom channel wall, which makes the mixer simple to integrate with a wide selection of microfluidic channel designs. The mixing occurs at a fluid-fluid density interface due to the acoustic radiation force; an analytical expression is derived to qualitatively describe this phenomenon. Only a small density difference in the range of 2-5% is required to achieve 150-270% peak broadening of a fluorescent sample between sheath flows, which we use as a measure of the mixing efficiency. The mixing efficiency is measured with regard to its sensitivity to the density difference, the fluid velocity and the transducer driving frequency. Transducers at different positions along the microchannel make it possible to compare the mixing of straight versus diagonal flows across the transducer surface. We finally demonstrate enhanced chemical lysis of E. coli K12 cells in the device due to active fluid mixing.

Many signals that induce angiogenesis have been identified; however, it is still not clear how these signals interact to shape the vascular system. We have developed a fluidic device for generation of molecular gradients in 3-dimensional cultures of complex tissues and organs in order to create an assay for precise induction and guidance of growing blood vessels. The device features a centrally placed culture chamber, flanked by channels attached to a perfusion system used to generate gradients. A separate network of vacuum channels permits reversible attachment of the device to a flat surface. We show that the fluidic device can be used to create growth factor gradients that induce directional angiogenesis in embryonic mouse kidneys and in clusters of differentiating stem cells. These results demonstrate that the device can be used to accurately manipulate complex morphogenetic processes with a high degree of experimental control.