Bone tissue engineering scaffolds should be designed to optimize mass transport, cell migration, and mechanical integrity to facilitate and enhance new bone growth. Although many scaffold parameters could be modified to fulfill these requirements, pore size is an important scaffold characteristic that can be rigorously controlled with indirect solid freeform fabrication. We explored the effect of pore size on bone regeneration and scaffold mechanical properties using polycaprolactone (PCL) scaffolds designed with interconnected, cylindrical orthogonal pores. Three scaffold designs with unique microarchitectures were fabricated, having pore sizes of 350, 550, or 800 microm. Bone morphogenetic protein-7 transduced human gingival fibroblasts were suspended in fibrin gel, seeded into scaffolds, and implanted subcutaneously in immuno-compromised mice for 4 or 8 weeks. We found that (1) modulus and peak stress of the scaffold/bone constructs depended on pore size and porosity at 4 weeks but not at 8 weeks, (2) bone growth inside pores depended on pore size at 4 weeks but not at 8 weeks, and (3) the length of implantation time had a limited effect on scaffold/bone construct properties. In conclusion, pore sizes between 350 and 800 microm play a limited role in bone regeneration in this tissue engineering model. Therefore, it may be advantageous to explore the effects of other scaffold structural properties, such as pore shape, pore interconnectivity, or scaffold permeability, on bone regeneration when designing PCL scaffolds for bone tissue engineering.

The skeleton shows greatest plasticity to physical activity-related mechanical loads during youth but is more at risk for failure during aging. Do the skeletal benefits of physical activity during youth persist with aging? To address this question, we used a uniquely controlled cross-sectional study design in which we compared the throwing-to-nonthrowing arm differences in humeral diaphysis bone properties in professional baseball players at different stages of their careers (n = 103) with dominant-to-nondominant arm differences in controls (n = 94). Throwing-related physical activity introduced extreme loading to the humeral diaphysis and nearly doubled its strength. Once throwing activities ceased, the cortical bone mass, area, and thickness benefits of physical activity during youth were gradually lost because of greater medullary expansion and cortical trabecularization. However, half of the bone size (total cross-sectional area) and one-third of the bone strength (polar moment of inertia) benefits of throwing-related physical activity during youth were maintained lifelong. In players who continued throwing during aging, some cortical bone mass and more strength benefits of the physical activity during youth were maintained as a result of less medullary expansion and cortical trabecularization. These data indicate that the old adage of "use it or lose it" is not entirely applicable to the skeleton and that physical activity during youth should be encouraged for lifelong bone health, with the focus being optimization of bone size and strength rather than the current paradigm of increasing mass. The data also indicate that physical activity should be encouraged during aging to reduce skeletal structural decay.exercise | intracortical remodeling | osteoporosis | peak bone mass

The advent of high-throughput measurements of gene expression and bioinformatics analysis methods offers new ways to study gene expression patterns. The primary goal of this study was to determine the time sequence for gene expression in a bone subjected to mechanical loading during key periods of the bone-formation process, including expression of matrix-related genes, the appearance of active osteoblasts, and bone desensitization. A standard model for bone loading was employed in which the right forelimb was loaded axially for 3 minutes per day, whereas the left forearm served as a nonloaded contralateral control. We evaluated loading-induced gene expression over a time course of 4 hours to 32 days after the first loading session. Six distinct time-dependent patterns of gene expression were identified over the time course and were categorized into three primary clusters: genes upregulated early in the time course, genes upregulated during matrix formation, and genes downregulated during matrix formation. Genes then were grouped based on function and/or signaling pathways. Many gene groups known to be important in loading-induced bone formation were identified within the clusters, including AP-1-related genes in the early-response cluster, matrix-related genes in the upregulated gene clusters, and Wnt/β-catenin signaling pathway inhibitors in the downregulated gene clusters. Several novel gene groups were identified as well, including chemokine-related genes, which were upregulated early but downregulated later in the time course; solute carrier genes, which were both upregulated and downregulated; and muscle-related genes, which were primarily downregulated. © 2011 American Society for Bone and Mineral Research.

Introduction The proximal humerus is relatively under investigated despite being the fourth most common site for osteoporotic fracture. Methods A cross-sectional study was performed to assess age-related changes in dual-energy x-ray absorptiometry (DXA) and peripheral quantitative computed tomography (pQCT) properties of the proximal humerus in a cohort of 170 healthy, white males. Results Regression models estimated considerable age-related loss of DXA measured bone quantity at the proximal humerus, with areal bone mineral density modeled to decline by 29% (95%CI, 17.5–35.0%) in the 50 years between ages 30 and 80 years (p<0.001). pQCT measures indicated aging was associated with progressive periosteal and endosteal expansion, with the later occurring more rapidly as indicated by age-related declines in cortical bone mass, area and thickness (all p<0.01). The net result of the density, mass and structural changes was a 26% (95%CI, 13.5–38.0%) decline in pQCT estimated proximal humerus bone strength in the 50 years between ages 30 and 80 years (p<0.001). Conclusion Aging is associated with considerable declines in proximal humeral bone health which, when coupled with a traumatic event such as a fall, may contribute to osteoporotic fracture at this site.

It is estimated that more than 90% of human genes express multiple mRNA transcripts due to alternative splicing. Consequently, the proteins produced by different splice variants will likely have different functions and expression levels. Several genes with splice variants are known in bone, with functions that affect osteoblast function and bone formation. The primary goal of this study was to evaluate the extent of alternative splicing in a bone subjected to mechanical loading and subsequent bone formation. We used the rat forelimb loading model, in which the right forelimb was loaded axially for 3 minutes, while the left forearm served as a non-loaded control. Animals were subjected to loading sessions every day, with 24 hours between sessions. Ulnae were sampled at 11 time points, from 4 hours to 32 days after beginning loading. RNA was isolated and mRNA abundance was measured at each time point using Affymetrix exon arrays (GeneChip® Rat Exon 1.0 ST Arrays). An ANOVA model was used to identify potential alternatively spliced genes across the time course, and five alternatively spliced genes were validated with qPCR: Akap12, Fn1, Pcolce, Sfrp4, and Tpm1. The number of alternatively spliced genes varied with time, ranging from a low of 68 at 12h to a high of 992 at 16d. We identified genes across the time course that encoded proteins with known functions in bone formation, including collagens, matrix proteins, and components of the Wnt/β-catenin and TGF-β signaling pathways. We also identified alternatively spliced genes encoding cytokines, ion channels, muscle-related genes, and solute carriers that do not have a known function in bone formation and represent potentially novel findings. In addition, a functional characterization was performed to categorize the global functions of the alternatively spliced genes in our data set. In conclusion, mechanical loading induces alternative splicing in bone, which may play an important role in the response of bone to mechanical loading.