No abstract

This study presents a novel single-switch high step-up dc-dc converter employing a quasi-resonant operation with high efficiency and low ripple continuous input current characteristics. In order to achieve a high voltage gain, a combination of coupled inductor and switched capacitor techniques is used in the proposed dc-dc converter. Moreover, utilising a series resonance capacitor with the leakage inductance of the coupled inductor leads to a resonant circuit. Subsequently, by employing a quasi-resonant operation, the switching loss of the proposed dc-dc converter has been reduced significantly. Operational analysis, mathematical derivation, component voltage and current ratings are well demonstrated in this study. Finally, the performance of the proposed circuit is evaluated through a 200 W laboratory prototype with 25 V input voltage and 400 V output voltage. The maximum efficiency achieved at full load is 96.4%.

In this paper, a new Semi-Quadratic High Step-Up Coupled-Inductor DC/DC Converter (SQHSUCI) with continuous input current and low voltage stress on semiconductor components is presented. The proposed structure employs a coupled-inductor (CI) and two power switches with simultaneous operation to achieve an extremely high voltage conversion ratio in a semiquadratic form. The voltage stress across the main power switch is clamped by two regenerative clamp capacitors. Here, the switching losses of both MOSFETs have been reduced by applying quasi-resonance operation of the circuit created by the leakage inductance of the CI along with the balancing and clamp capacitors. Therefore, by considering the high gain conversion ratio along with low voltage stress on components, the magnetic and semiconductors losses of the SQHSUCI are reduced significantly. Also, the energy stored in the leakage inductance of CI is recycled to the output capacitor. These features make the proposed SQHSUCI more suitable for industrial applications. The operation principle, steady-state and also comparisons with other related converters in Continuous Conduction Mode (CCM) are discussed in detail. Finally, experimental results of a prototype with 20 V input and 200 W-200 V output at 50 kHz switching frequency, verify the theoretical advantages of the proposed strategy.

In this paper, a new non-isolated full soft-switching step-up DC/DC converter is introduced with a continuous input current for renewable energy applications. The use of a Three-Winding Coupled-Inductor (TWCI) along with a Voltage Multiplier (VM), enables the proposed converter to enhance the voltage gain with lower turns ratios and duty cycles. Also, a lossless regenerative passive clamp circuit is employed to limit the voltage stress across the power switch. In addition to Zero Current Switching (ZCS) performance at the turn-on instant of the power switch, the turn-off current value is also alleviated by adopting a Quasi-Resonance (QR) operation between the leakage inductor of the TWCI and middle capacitors. Moreover, the current of all diodes reaches zero with a slow slew rate, which leads to the elimination of the reverse recovery problem in the converter. Soft-switching of the power switch and all the diodes in the proposed converter significantly reduces the switching power dissipations. Therefore, the presented converter can provide a high voltage gain ratio with high efficiency. Steadystate analysis, comprehensive comparisons with other related converters, and design considerations are discussed in detail. Finally, a 160 W prototype with 200 V output voltage is demonstrated to justify the theoretical analysis.

Summary This paper presents a novel transformerless semi‐quadratic buck‐boost converter (SQBuBoC). In the proposed SQBuBoC, two power switches with simultaneous operation are used and a higher step‐up/step‐down voltage conversion ratio is achieved compared with the traditional buck‐boost, Cuk, single‐ended primary‐inductor converter, and Zeta converters. The positive polarity of the output voltage, along with low ripple continuous input current and common ground between the source and the output voltages, are some features that make the suggested topology more suitable for many applications with wide range of output voltage such as photovoltaic systems. Moreover, the total voltage stress across the power switches in this converter is lower than the cascade boost, and the traditional buck‐boost converters led to power MOSFETs selection with lower drain‐source ON resistance (Rds) and efficiency improvement. All the steady‐state analysis and comparisons in continuous conduction mode (CCM) are discussed in details. In addition, to study the low frequency behavior of the SQBuBoC by means of the state‐space averaging technique, the small and large signal models of this converter in CCM are presented. Finally, the SQBuBoC analysis is justified using experimental results of a 50 W step‐up 25 V to 120 V and a 28 W step‐down 25 V to 14 V laboratory prototypes.

No abstract

In this paper, a novel non-isolated Single-Switch Quadratic Boost Coupled-Inductor (SSQBCI) DC/DC converter with continuous input current and low voltage stress on the switching component is presented. The suggested structure is based on the traditional quadratic boost converter. In this new topology, to achieve an ultra-high voltage gain without large duty cycle, a Coupled-Inductor (CI) along with a Voltage Multiplier (VM) are employed. The magnetic energy stored in the leakage inductor of the CI is recycled by a regenerative passive clamp capacitor that is connected with the switch in parallel, which helps to limit the maximum voltage across the switch. Therefore, to reduce the switch conduction loss and improve the efficiency, a switch with the low static drain-to-source ON-resistance can be used. Moreover, the low voltage stress on the output side diode alleviates the reverse recovery loss. The steady-state operating principle, comparisons with other related topologies and also design considerations in Continuous Conduction Mode (CCM) will be analyzed in detail. Finally, the performance of the proposed SSQBCI is verified by experimental results using a prototype with 30V input and 200V-160 W output operation at a constant switching frequency 50 kHz.

No abstract