Clinacanthus nutans is a well recognized medicinal herb for its high phytochemical contents. Several aspects may contribute to the phytochemical contents, and thus determine the quality and efficacy of an herb. An experiment was conducted using a completely randomized design (CRD) with five replications, in a factorial arrangement of treatments. including two plant parts harvested at two different stages such as young leaves, young stems, matured leaves and matured stems, and four different storage durations such as 1, 2, 3 and 4 days. The study was aimed at determining how storage duration affects selected phytochemical contents of different plant parts of C. nutans at different harvesting stages. Total phytochemical content, total flavonoids content and DPPH radical scavenging activities are higher in young plants than in old plants, moreover, all those compounds are higher in leaves than in stems, and decrease gradually due to storage. Phytochemical, ascorbic acid and chlorophyll content of C. nutans differ among different plant parts and change due to storage. In general, young plant parts contain higher amount of phytochemicals, ascorbic acid and chlorophyll compared with matured parts confirming that phytochemicals content of C. nutans decreases when plants tend to maturity. Prolonged storage reduces phytochemical, ascorbic acid and chlorophyll content of C. nutans,which demands fresh use of this medicinal herb to avoid phytochemical losses. Further research focusing on the proper storage is necessary to minimize phytochemicals losses of C. nutans.

Currently, many researchers interested studying waste materials to recycle them or reuse them in new products. From the sustainable perspective development, it is necessary to implement new technologies to help reduce waste and thus minimize the environmental problems associated with disposal. In this study, the preparation of SiO2-Na2O-CaO-P2O5 (SNCP) glass-ceramic is composed of Soda Lime Silicate (SLS), Clam Shell (CS), Na2CO3 and P2O5 in the ratio of 50: 25: 20: 5 respectively. The waste materials that were used for fabricate glass-ceramic are SLS and CS. All the compounds were mixed to fabricate the SNCP glass-ceramic through solid state reaction. The samples were investigated through X-ray diffraction (XRD), field emission microscope (FESEM) and density measurement. The samples were sintered at temperature 550°C, 650°C, 750°C, 850°C until 950°C. The main phase obtained from XRD analysis is Sodium Calcium Silicate, Na2CaSiO4 with cubic crystal system at 550°C. The highest intensity phase of the diffraction peak is (220) and at the angle 33.7°. There was new peak presence at right side of the main phase Na2CaSiO4, which belong to Silicon Phosphate, SiP2O7 at 650°C and 750°C.When heat treatment increased at 850°C - 950°C, the main phase is Combeite, Na4Ca4(Si6O18) at diffraction peak (220) with rhombohedral crystal system which is assigned to high crystallization temperature (Tc). The density of samples increases at 550°C - 750°C and decreases when heat treatment 850°C - 950°C. Sample density decreases at heat treatment 850°C - 950°C due to increases of sample lattice parameter. FESEM analysis showed that the grain size and porosity increased when the heat treatment increased.