Bottom-up nanostructure assembly has been a central theme of materials synthesis over the past few decades. Semiconductor quantum dots and nanowires provide additional degrees of freedom for charge confinement, strain engineering, and surface sensitivity-properties that are useful to a wide range of solid state optical and electronic technologies. A central challenge is to understand and manipulate nanostructure assembly to reproducibly generate emergent structures with the desired properties. However, progress is hampered due to the interdependence of nucleation and growth phenomena. Here we show that by dynamically adjusting the growth kinetics, it is possible to separate the nucleation and growth processes in spontaneously formed GaN nanowires using a two-step molecular beam epitaxy technique. First, a growth phase diagram for these nanowires is systematically developed, which allows for control of nanowire density over three orders of magnitude. Next, we show that by first nucleating nanowires at a low temperature and then growing them at a higher temperature, height and density can be independently selected while maintaining the target density over long growth times. GaN nanowires prepared using this two-step procedure are overgrown with three-dimensionally layered and topologically complex heterostructures of (GaN/AlN). By adjusting the growth temperature in the second growth step either vertical or coaxial nanowire superlattices can be formed. These results indicate that a two-step method allows access to a variety of kinetics at which nanowire nucleation and adatom mobility are adjustable.
Almost all electronic devices utilize a pn junction formed by random doping of donor and acceptor impurity atoms. We developed a fundamentally new type of pn junction not formed by impurity-doping, but rather by grading the composition of a semiconductor nanowire resulting in alternating p and n conducting regions due to polarization charge. By linearly grading AlGaN nanowires from 0% to 100% and back to 0% Al, we show the formation of a polarization-induced pn junction even in the absence of any impurity doping. Since electrons and holes are injected from AlN barriers into quantum disk active regions, graded nanowires allow deep ultraviolet LEDs across the AlGaN band-gap range with electroluminescence observed from 3.4 to 5 eV. Polarization-induced p-type conductivity in nanowires is shown to be possible even without supplemental acceptor doping, demonstrating the advantage of polarization engineering in nanowires compared with planar films and providing a strategy for improving conductivity in wide-band-gap semiconductors. As polarization charge is uniform within each unit cell, polarization-induced conductivity without impurity doping provides a solution to the problem of conductivity uniformity in nanowires and nanoelectronics and opens a new field of polarization engineering in nanostructures that may be applied to other polar semiconductors.
Polarization-induced nanowire light emitting diodes (PINLEDs) are fabricated by grading the Al composition along the c-direction of AlGaN nanowires grown on Si substrates by plasma-assisted molecular beam epitaxy (PAMBE). Polarization-induced charge develops with a sign that depends on the direction of the Al composition gradient with respect to the [0001] direction. By grading from GaN to AlN then back to GaN, a polarization-induced p-n junction is formed. The orientation of the p-type and n-type sections depends on the material polarity of the nanowire (i.e., Ga-face or N-face). Ga-face material results in an n-type base and a p-type top, while N-face results in the opposite. The present work examines the polarity of catalyst-free nanowires using multiple methods: scanning transmission electron microscopy (STEM), selective etching, conductive atomic force microscopy (C-AFM), and electroluminescence (EL) spectroscopy. Selective etching and STEM measurements taken in annular bright field (ABF) mode demonstrate that the preferred orientation for catalyst-free nanowires grown by PAMBE is N-face, with roughly 10% showing Ga-face orientation. C-AFM and EL spectroscopy allow electrical and optical differentiation of the material polarity in PINLEDs since the forward bias direction depends on the p-n junction orientation and therefore on nanowire polarity. Specifically, C-AFM reveals that the direction of forward bias for individual nanowire LEDs changes with the polarity, as expected, due to reversal of the sign of the polarization-induced charge. Electroluminescence measurements of mixed polarity PINLEDs wired in parallel show ambipolar emission due to the mixture of p-n and n-p oriented PINLEDs. These results show that, if catalyst-free III-nitride nanowires are to be used to form polarization-doped heterostructures, then it is imperative to understand their mixed polarity and to design devices using these nanowires accordingly.
Bottom-up nanowires are attractive for realizing semiconductor devices with extreme heterostructures because strain relaxation through the nanowire sidewalls allows the combination of highly lattice mismatched materials without creating dislocations. The resulting nanowires are used to fabricate light-emitting diodes (LEDs), lasers, solar cells, and sensors. However, expensive single crystalline substrates are commonly used as substrates for nanowire heterostructures as well as for epitaxial devices, which limits the manufacturability of nanowire devices. Here, nanowire LEDs directly grown and electrically integrated on metal are demonstrated. Optical and structural measurements reveal high-quality, vertically aligned GaN nanowires on molybdenum and titanium films. Transmission electron microscopy confirms the composition variation in the polarization-graded AlGaN nanowire LEDs. Blue to green electroluminescence is observed from InGaN quantum well active regions, while GaN active regions exhibit ultraviolet emission. These results demonstrate a pathway for large-scale fabrication of solid state lighting and optoelectronics on metal foils or sheets.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.