No abstract

A mesocosm study was evaluated to elucidate the influence of amendments such as microbial consortium, plant (Vetiveria zizanioides), bulking agent (wheat husk) and nutrients on remediation of oil sludge over a period of 90 days. The experiment was conducted in a 15 m 2 plot which was divided into eight units comprising of soil sludge mixture (1:1) at CSIR-NEERI premises. During the experiment, oil degradation was estimated gravimetrically and polyaromatic hydrocarbons (PAHs) were quantified on GC-MS. Additionally, dehydrogenase activity was also monitored. The treatment integrated with bulking agent, nutrients, consortium and plant resulted in 28-fold increased dehydrogenase activity and complete mineralization of higher PAHs. Furthermore, 72.8 % total petroleum hydrocarbons (TPH) degradation was observed in bulked treatment with plant, nutrients and consortium followed by 69.6 and 65.4 % in bioaugmented treatments with and without nutrients, respectively, as compared to control (33.4 %). A lysimeter study was also conducted simultaneously using Vetiver and consortium to monitor groundwater contamination by heavy metals in oil sludge which showed a marked decrease in the concentrations of metals such as lead and cadmium in leachates. This study validates a holistic approach for remediation of oil sludge contaminated soils/sites which is a burning issue since decades by the use of microbe assisted phytoremediation technology which not only solves the problem of oil contamination but also takes care of heavy metal contamination.

Polybrominated diphenyl ethers (PBDEs) used extensively over the past 3 decades as flame retardants in most types of polymers, all over the world, have been identified as global pollutants. PBDEs pose various health problems such as thyroid hormone disruption, permanent learning and memory impairment, behavioral changes, hearing deficits, delayed puberty onset, fetal malformations, and possibly cancer. Many measurements of PBDEs in various matrices from Sweden, Holland, Japan, the USA, and elsewhere have been reported, but few measurements are available for India. In this study, a preliminary screening of different congeners of PBDEs has been performed in different old electronic and consumer products with an objective to build capacity in order to analyze PBDEs and BFRs. Six different samples, foam from upholstery, motherboard of a computer, children toy composite sample, old vanishing window blind sample, electrical wire sample, and PVC flooring sample, were collected and analyzed for the presence of the following PBDE congeners: BDE-28, BDE-47, BDE-99, BDE-100, BDE-153, BDE-154, BDE-183, and BDE-209. It was found that three out of six samples were positive for the presence of PBDEs. Three congeners were detected in the samples, i.e., BDE-47, BDE-153, and BDE-209, of which, highest concentration was of BDE-209. Among the samples, motherboard of computer showed the highest concentration of BDE-209 followed by window blind and foam from upholstery. The results of this preliminary investigation indicate that PBDEs are still present in the old consumer products which can be an important additional source of exposure to the population.

The 2,4-dichlorophenoxy acetic acid (2,4-D) is used as a systemic herbicide to control broadleaf weeds in wheat, corn, range land/pasture land, sorghum, and barley. In this study, a fast and efficient method is developed by selection of modified extraction apparatus and high-performance liquid chromatography (HPLC)-UV conditions for the determination of 2,4-D in soil samples. The method is applied to the study of soil samples collected from the agricultural field. The herbicide is extracted from soil samples by acetonitrile in a modified Soxhlet apparatus. The advantages of the apparatus are that it uses small volume of organic solvent, reduced time of extraction, and better recovery of the analyte. The extract is filtered using a very fine microfiber paper. The total extract is concentrated in a rotatory evaporator, dried under ultrahigh pure N2, and finally reconstituted in 1 mL of acetonitrile. HPLC-UV at 228 nm is used for analysis. The herbicide is identified and quantitated using the HPLC system. The method is validated by the analysis of spiked soil samples. Recoveries obtained varied from 85% to 100% for spiked soil samples. The limit of quantitation (LOQ) and the limit of detection (LOD) are 0.010 and 0.005 parts per million (ppm), respectively, for spiked soil samples. The LOQ and LOD are 0.006 and 0.003 ppm for unspiked soil samples. The measured concentrations of 2,4-D in spiked soil samples are between 0.010 and 0.020 ppm with an average of 0.016 +/- 0.003 ppm. For unspiked soil samples it is between 0.006 ppm and 0.012 ppm with an average of 0.009 +/- 0.002 ppm. The measured concentrations of 2,4-D in soil samples are generally low and do not exceed the regulatory agencies guidelines.

No abstract

No abstract

Present work describes microbial degradation of selected polychlorinated biphenyls (PCBs) congeners in Clophen oil which is used as transformer oil and contains high concentration of PCBs. Indigenous PCBs degrading bacteria were isolated from Clophen oil contaminated soil using enrichment culture technique. A 15 days study was carried out to assess the biodegradation potential of two bacterial cultures and their consortium for Clophen oil with a final PCBs concentration of 100 mg kg(-1). The degradation capability of the individual bacterium and the consortium towards the varying range of PCBs congeners (di- through hepta-chlorobiphenyls) was determined using GCMS. Also, dehydrogenase enzyme was estimated to assess the microbial activity. Maximum degradation was observed in treatment containing consortium that resulted in up to 97 % degradation of PCB-44 which is a tetra chlorinated biphenyl whereas, hexa chlorinated biphenyl congener (PCB-153) was degraded up to 90 % by the consortium. This indicates that the degradation capability of microbial consortium was significantly higher than that of individual cultures. Furthermore, the results suggest that for degradation of lower as well as higher chlorinated PCB congeners; a microbial consortium is required rather than individual cultures.

Industrial effluent treatment plants (ETPs) are very important in protecting the environment and different life forms from harmful industrial waste. Hence, the efficiency of ETPs must be regularly monitored, particularly after major repair or replacement work. Present study evaluated the performance of an ETP over a period of 4 months, during which aeration tank (T1) of the activated sludge unit was replaced with a new one (T2). System had to be maintained operational during this transition, which warranted close monitoring of the system performance due to the daily load of hazardous industrial wastewater. Analysis showed that the raw wastewater was highly variable in composition and contained many hazardous organic and inorganic pollutants, such as heavy metals, bisphenol A and cyanoacetylurea. It showed significant toxicity against HepG2 cells in vitro. However, the ETP was found to successfully treat and detoxify the wastewater. Denaturing gradient gel electrophoresis (DGGE) analysis showed large temporal fluctuations in the ETP microbial community, which is consistent with the variable composition of wastewater. It indicated that functional stability of the ETP was not associated with stability of the microbial community, probably due to high microbial biodiversity and consequently high functional redundancy. In conclusion, the CETP showed consistent level of detoxification and microbial community dynamics after switching to T2, indicating successful development, acclimatization and commissioning of T2.