No abstract

Integrated Access and Backhaul (IAB) is being investigated as a means to overcome deployment costs of ultradense 5G millimeter wave (mmWave) networks by realizing wireless backhaul links to relay the access traffic. For the development of these systems, however, it is fundamental to validate the performance of IAB in realistic scenarios through end-toend system level simulations. In this paper, we shed light on the most recent standardization activities on IAB, and compare architectures with and without IAB in mmWave deployments. While it is well understood that IAB networks reduce deployment costs by obviating the need to provide wired backhaul to each cellular base-station, in this paper we demonstrate the celledge throughput advantage offered by IAB using end-to-end system level simulations. We further highlight some research challenges associated with this architecture that will require further investigations.

Abstract-Recent progress in single channel full-duplex (SC-FD) radio design [1]- [4] has attracted the attention of many researchers. A SC-FD transceiver is capable of transmitting and receiving on the same frequency at the same time, which will have a great impact on the design and performance of current wireless networks that are based on half duplex designs. This paper analyzes the effects of adopting SC-FD enabled base stations in a cellular system with legacy mobile stations. We use a multi-cell analytical model based on stochastic geometry to derive the theoretical performance gain of such a system. To validate the performance using a realistic setting, we conduct extensive simulations for a multi-cell OFDMA system. Both sets of results show that a full-duplex design for a cellular system, while not quite doubling system capacity, does greatly increases capacity over traditional cellular systems. Our results show that the uplink, compared with the downlink, is more susceptible to the extra interference caused by using the same frequency in both directions.

Abstract-Recent progress in establishing the capability of radios to operate in full duplex mode on a single channel has been attracting growing attention from many researchers. We extend this work by considering the application to small cells, in particular resource-managed cellular systems similar to the TDD variant of LTE. We derive conditions where full duplex operation provides improved throughput compared to half duplex for a single cell scenario. We present a hybrid scheduler that defaults to half duplex operation but can assign full duplex timeslots when it is advantageous to do so. We compare the performance of such a scheduler with a traditional half duplex scheduler in terms of throughput and energy efficiency. Our simulation results show that we achieve as much as 81% of the capacity doubling promised by full duplex, with limitations deriving from interference effects specific to full duplex operation.

Licensed-Assisted Access (LAA) enabled LTE operators to access unlicensed spectrum while adhering to Listen-Before-Talk (LBT) requirements. LAA is based on enhancements over 4G LTE technology. Differently, 5G New Radio (NR) technology is being designed from the start to support operation in unlicensed bands through a technology referred to as NRbased access to unlicensed spectrum (NR-U). A large amount of unlicensed spectrum has been allocated in millimeter-wave (mmWave) bands, making it an attractive candidate for NR-U. However, the propagation characteristics in mmWave often require beam-based transmissions. Beam-based transmissions enhance spatial reuse, but also complicate interference management due to the dynamic nature of the directional antennas. Therefore, some major design principles need to be revisited in NR-U to address coexistence. This paper elaborates on the design challenges, opportunities, and solutions for NR-U by taking into account beam-based transmissions and the worldwide regulatory requirements. In particular, different problems and the potential solutions related to channel access procedures, frame structure, initial access procedures, HARQ procedures, and scheduling schemes are discussed.

Abstract-Full duplex (FD) communications has the potential to double the capacity of a half duplex (HD) system at the link level. However, in a cellular network, FD operation is not a straightforward extension of half duplex operations. The increased interference due to a large number of simultaneous transmissions in FD operation and realtime traffic conditions limits the capacity improvement. Realizing the potential of FD requires careful coordination of resource allocation among the cells as well as within the cell. In this paper, we propose a distributed resource allocation, i.e., joint user selection and power allocation for a FD multi-cell system, assuming FD base stations (BSs) and HD user equipment (UEs). Due to the complexity of finding the globally optimum solution, a sub-optimal solution for UE selection, and a novel geometric programming based solution for power allocation, are proposed. The proposed distributed approach converges quickly and performs almost as well as a centralized solution, but with much lower signaling overhead. It provides a hybrid scheduling policy which allows FD operations whenever it is advantageous, but otherwise defaults to HD operation. We focus on small cell systems because they are more suitable for FD operation, given practical self-interference cancellation limits. With practical self-interference cancellation, it is shown that the proposed hybrid FD system achieves nearly two times throughput improvement for an indoor multi-cell scenario, and about 65% improvement for an outdoor multi-cell scenario compared to the HD system.

Abstract-Recent advances in antenna and circuit design enable radios that operate in full duplex mode on a single channel with very low residual self-interference. In this paper, the use of such full duplex radios in a wireless local area network (WLAN) is explored. Different scenarios in which the full duplex transmission can be exploited are studied. A distributed full duplex MAC design based on IEEE 802.11 DCF that adopts to the traffic conditions is proposed. The proposed MAC design works for both ad hoc and infrastructure modes of WLAN and takes into consideration new interference and contention during full duplex transmissions. OPNET simulations comparing the performance of the proposed MAC with traditional half duplex based IEEE 802.11 DCF show that the new MAC protocol provides up to 88% throughput gain in a heavily loaded network.

Recent advances in self-interference cancellation enable radios to transmit and receive on the same frequency at the same time. Such a full duplex radio is being considered as a potential candidate for the next generation of wireless networks due to its ability to increase the spectral efficiency of wireless systems. In this paper, the performance of full duplex radio in small cellular systems is analyzed by assuming full duplex capable base stations and half duplex user equipment. However, using only full duplex base stations increases interference leading to outage. We therefore propose a mixed multi-cell system, composed of full duplex and half duplex cells. A stochastic geometry based model of the proposed mixed system is provided, which allows us to derive the outage and area spectral efficiency of such a system. The effect of full duplex cells on the performance of the mixed system is presented under different network parameter settings. We show that the fraction of cells that have full duplex base stations can be used as a design parameter by the network operator to target an optimal tradeoff between area spectral efficiency and outage in a mixed system.