A distinct step in the isotherm occurs during the adsorption of CO2 on MIL-53 at 304 K. Such behavior is neither observed during the adsorption of CH4 on MIL-53 nor during the adsorption on the isostructural MIL-47. This phenomenon seems to be due to a different mechanism than that of previous adsorption steps on MOF samples. It is suggested that a breathing behavior is induced in MIL-53 during CO2 adsorption.

Mesoporous MOFs MIL-100 and MIL-101 adsorb huge amounts of CO2 and CH4. Characterization was performed using both manometry and gravimetry in different laboratories for isotherms coupled with microcalorimetry and FTIR to specify the gas-solid interactions. In particular, the uptake of carbon dioxide in MIL-101 has been shown to occur with a record capacity of 40 mmol g(-1) or 390 cm3STP cm(-3) at 5 MPa and 303 K.

The unusual adsorption behavior of CO2 in a nanoporous hybrid metal– organic solid is discussed (see figure). The results indicate that the gas adsorption–desorption step is related to a breathing phenomenon. This study also suggests that the main interactions responsible for the breathing phenomenon are strong guest–framework CO2–OH interactions as well as CO2–CO2 interactions along the tunnels present in the structure.

A new aluminum trimesate Al12O(OH)18(H2O)3(Al2(OH)4)[btc]6.24H2O, denominated MIL-96, was synthesized under mild hydrothermal conditions (210 degrees C, 24 h) in the presence of 1,3,5-benzenetricarboxylic acid (trimesic acid or H3btc) in water. Hexagonal crystals, allowing a single-crystal XRD analysis, are grown from a mixture of trimethyl 1,3,5-benzenetricarboxylate (Me3btc), HF, and TEOS. The MIL-96 structure exhibits a three-dimensional (3D) framework containing isolated trinuclear mu3-oxo-bridged aluminum clusters and infinite chains of AlO4(OH)2 and AlO2(OH)4 octahedra forming a honeycomb lattice based on 18-membered rings. The two types of aluminum groups are connected to each other through the trimesate species, which induce corrugated chains of aluminum octahedra, linked via mu2-hydroxo bonds with the specific -cis-cis-trans- sequence. The 3D framework of MIL-96 reveals three types of cages. Two of them, centered at the special positions 0 0 0 and 2/3 1/3 1/4, have estimated pore volumes of 417 and 635 A3, respectively, and encapsulate free water molecules. The third one has a smaller pore volume and contains disordered aluminum octahedral species (Al(OH)6). The solid-state NMR characterization is consistent with crystal structure and elemental and thermal analyses. The four aluminum crystallographic sites are resolved by means of 27Al 3QMAS technique. This product is able to sorb both carbon dioxide and methane at room temperature (4.4 mmol.g(-1) for CO2 and 1.95 mmol.g(-1) for CH4 at 10 bar) and hydrogen at 77 K (1.91 wt % under 3 bar).

This investigation is based on a combination of experimental tools completed by a computational approach to deeply characterize the unusual adsorption behavior of the flexible MIL-53(Fe) in the presence of short linear alkanes. In contrast to the aluminum or chromium analogues we previously reported, the iron MIL-53 solid, which initially exhibits a closed structure in the dry state, shows more complex adsorption isotherms with multisteps occurring at pressures that depend on the nature of the alkane. This behavior has been attributed to the existence of four discrete pore openings during the whole adsorption process. Molecular simulations coupled with in situ X-ray powder diffraction were able to uncover these various structural states.

The adsorption of C1 to C4 linear hydrocarbons in the flexible metal organic framework MIL-53(Cr) has been followed by adsorption manometry coupled with microcalorimetry and Synchrotron X-ray powder diffraction. This experimental investigation was completed by molecular modeling. In the case of methane, the solid remains rigid whatever the adsorbate amount. However for the C2-C4 series, an increasing flexibility of the structure is observed, which is ascribed first to a breathing of the material from a large pore to a narrow pore form followed by a further expansion at high pressure. The collected thermodynamic and structural information suggests that a minimum adsorption enthalpy of ca. 20 kJ mol (-1) in the initial large pore structure of MIL-53(Cr) is required to induce the structural transition "large to narrow pore". Further, the enthalpy of adsorption can be used to predict the pressure at which the structure reopens. Finally, the magnitude of the breathing can be related to the size of the probe molecule via the van der Waals volume. The above trends have been successfully verified in the case of water and carbon dioxide. This combined experimental and theoretical approach gives the first elements for the prediction of whether or not the MIL53 and similar flexible structures will respond to gas loading and what would be the pressure required and further the amplitude of the induced breathing.

One of the technological problems that face society today is the environmentally friendly and economically feasible separation, recovery, and recovery/reuse of vapors and gases. Several examples are currently of interest: the selective recovery of solvents, the recovery of greenhouse gases, and the purification of hydrogen. Many processes include an adsorption step in which microporous adsorbents, such as activated carbon and zeolites, are used. Recently a new class of porous materials have found interest: these metal organic frameworks (MOFs) [1,2] or metal coordination polymers [3] are built up from inorganic subnetworks and organic complexing molecules (phosphonates, carboxylates, sulfonates). These subnetworks often contain divalent or trivalent cations connected by organic groups such as carboxylates. Such structures possess tunnels or cavities with pore sizes between 3 and 35 . Several of these organic-inorganic hybrid porous solids [4][5][6][7][8][9][10][11] have the interesting feature of being selectively flexible during the adsorption process by means of a breathing [12] or gate-opening process, [9] which depends on the nature of the adsorptive. Examples discovered by Ferey and coworkers include flexible porous carboxylates formed by chains of metallic centers (MIL-53, -69) [13,14] and with metalcenter trimers (MIL-88A).[15] These solids have shown to "breath" with unprecedented increases in volume between 50 and 85 % depending on the nature of the fluid. A consequence of this particular property is the possibility to develop novel selective separation and storage processes that could be less expensive than existing processes.In many adsorption processes since the presence of water is detrimental, it is often removed using a precolumn. In the [*] Dr.

In addition to its high thermal stability, repetitive hydration/dehydration tests have revealed that the porous zirconium terephthalate UiO-66 switches reversibly between its dehydroxylated and hydroxylated versions. The structure of its dehydroxylated form has thus been elucidated by coupling molecular simulations and X-ray powder diffraction data. Infrared measurements have shown that relatively weak acid sites are available while microcalorimetry combined with Monte Carlo simulations emphasize moderate interactions between the UiO-66 surface and a wide range of guest molecules including CH(4), CO, and CO(2). These properties, in conjunction with its significant adsorption capacity, make UiO-66 of interest for its further evaluation for CO(2) recovery in industrial applications. This global approach suggests a strategy for the evaluation of metal-organic frameworks for gas-based applications.