Advances in the growth processes of 4H-SiC epitaxial layers have led to the continued expansion of epilayer thickness, allowing for the detection of more penetrative radioactive particles. We report the fabrication and characterization of high-resolution Schottky barrier radiation detectors on 250 μm thick n-type 4H-SiC epitaxial layers, the highest reported thickness to date. Several 8 × 8 mm2 detectors were fabricated from a diced 100 mm diameter 4H-SiC epitaxial wafer grown on a conductive 4H-SiC substrate with a mean micropipe density of 0.11 cm−2. From the Mott–Schottky plots, the effective doping concentration was found to be in the range (0.95–1.85) × 1014 cm−3, implying that full depletion could be achieved at ∼5.7 kV (0.5 MV/cm at the interface). The current-voltage characteristics demonstrated consistently low leakage current densities of 1–3 nA/cm2 at a reverse bias of −800 V. This resulted in the pulse-height spectra generated using a 241Am alpha source (5486 keV) manifesting an energy resolution of less than 0.5% full width at half maximum (FWHM) for all the detectors at −200 V. The charge collection efficiencies (CCEs) were measured to be 98–99% with no discernable correlation to the energy resolution. A drift-diffusion model fit to the variation of CCE as a function of bias voltage, revealed a minority carrier diffusion length of ∼10 μm. Deep level transient spectroscopy measurements on the best resolution detector revealed that the excellent performance was the result of having ultralow concentrations of the order of 1011 cm−3 lifetime limiting defects—Z1/2 and EH6/7.

Articles you may be interested in Generalized current-voltage analysis and efficiency limitations in non-ideal solar cells: Case of Cu2ZnSn(SxSe1−x)4 and Cu2Zn(SnyGe1−y)(SxSe1−x)4

No abstract

Defects present in ZnO nanocrystals prepared by a wet chemical method have been characterized by photoluminescence (PL) and positron annihilation spectroscopy (PAS) techniques. The as-prepared sample was heat treated at different temperatures to obtain nanocrystals in the size range of 19-39 nm. X ray diffractograms confirmed the single-phase wurtzite structure formation. Photoluminescence measurements showed a strong violet band at 434 nm, which has been identified as due to electronic transitions from the zinc interstitial defect level to the top of the valence band. A marked decrease in the intensity of the violet emission with increasing heat-treatment temperature has been observed, which is attributed to recombination of zinc interstitials with zinc vacancies. Positron annihilation spectroscopy has been employed to understand the dynamics of the vacancy-type defects and their annealing behavior. The observed variation of the defect related lifetime components with heat-treatment temperature has been successfully explained by using a three-state trapping model. The results of PL and PAS studies in the present case are found to be complementary to each other. © 2007 American Institute of Physics

No abstract

Schottky barrier detectors (SBDs) require larger surface areas than conventional electronics to increase the detection efficiency although such SBDs manifest large diode ideality factors due to inhomogeneous areal distribution of surface barrier height (SBH). Inhomogeneous SBH distributions lead to various current flow mechanisms in SBDs, which need to be identified to optimize detector performance. In this Letter, we identify the current flow mechanism in large area Schottky barrier diodes for radiation detection fabricated on 150 μm thick n-4H–SiC epitaxial layers. The analysis of temperature-dependent forward current–voltage (I–V–T) characteristics of SBDs revealed two linear regions in current–voltage curves up to 450 K, one corresponding to the current flow through a low barrier patch, while the other corresponds to that of average barrier distribution. Applying a SBH distribution model to the reverse I–V–T characteristics, an activation energy of 0.76 eV for the current flow over the Schottky barrier was calculated. The activation energy did not directly correspond to any of the defect levels observed from the deep level transient spectroscopy (DLTS). Above 450 K, a Schottky type barrier lowering suggested a current flow through a low barrier patch of ≈ 0.8 eV. The absence of any SBH lowering below 450 K indicated that the current corresponded to a neutrally charged trap level at ≈ 0.6 eV below the conduction band edge, which was consistent with DLTS measurements revealing the presence of an electron trap level Z1/2 at 0.59 eV below the conduction band edge.

Articles you may be interested inChemical effect of Si+ ions on the implantation-induced defects in ZnO studied by a slow positron beam J. Appl. Phys. 113, 043506 (2013); 10.1063/1.4789010 Positron annihilation study of the interfacial defects in ZnO nanocrystals: Correlation with ferromagnetism Positron annihilation spectroscopic studies of solvothermally synthesized ZnO nanobipyramids and nanoparticles

No abstract