a b s t r a c tAn Mg-7Sn-1Al-1Zn alloy known to have excellent extrudability and superior strength was subjected to artificial cooling during indirect extrusion by directly spraying water onto the extruded rod at the die exit. The results obtained revealed that this artificial cooling dramatically reduces the temperature of the deformation zone during extrusion, thereby creating a finer grain size, an intensified texture and a greater amount of precipitates when compared to extrusion without artificial cooling. The yield and tensile strength of the extruded alloy is also significantly improved, which is attributed to the effects of grain refinement in combination with an enhanced texture and precipitate hardening.

Without post-manufacture HIPing the fatigue life of electron beam melting (EBM) additively manufactured parts is currently dominated by the presence of porosity, exhibiting large amounts of scatter. Here we have shown that the size and location of these defects is crucial in determining the fatigue life of EBM Ti-6Al-4V samples. X-ray computed tomography has been used to characterise all the pores in fatigue samples prior to testing and to follow the initiation and growth of fatigue cracks. This shows that the initiation stage comprises a large fraction of life (>70%). In these samples the initiating defect was often some way from being the largest (merely within the top 35% of large defects). Using various ranking strategies including a range of parameters, we found that when the proximity to the surface and the pore aspect ratio were included the actual initiating defect was within the top 3% of defects ranked most harmful. This lays the basis for considering how the deposition parameters can be optimised to ensure that the distribution of pores is tailored to the distribution of applied stresses in additively manufactured parts to maximise the fatigue life for a given loading cycle.

Ti-6Al-4V parts, produced by selective electron beam melting additive manufacturing, have been studied by X-ray computed tomography (XCT) to track pore closure during a standard hot isostatic pressing (HIPing) cycle. Comparison of repeated XCT scans before and after HIPing, on worst-case samples with different geometries, confirmed that all internal porosity was shrunk to below the resolution limit of the equipment used (~5 µm) following the HIPing cycle, apart from defects with surface connected ligaments.