Direct Laser Fabrication is a promising new manufacturing technology coming from laser cladding process. From a coaxial nozzle, powder is fed through a laser beam on a substrate. The powder melting and solidification processes lead to the fabrication of a part layer by layer. In this work 316L stainless steel powder is used to form laser tracks on a low carbon steel substrate. The layer geometry is an important process characteristic to control the final part of fabrication. This paper presents analytical relationships between the laser tracks geometrical characteristics (width, height, area, penetration depth) and the processing parameters (laser power P, scanning speed V and powder mass flow Q m). Three values of each processing parameters are fixed and so 27 different experiments have been made and analyzed. The validity of these results is discussed studying the correlation coefficient R, the graphical analysis of the residuals and the uncertainty evaluations. Two kinds of models are studied to predict the form and the geometrical characteristics of the single laser tracks cross sections. The first one is an analytical model in which the distribution of the powder in the feed jet is supposed to govern the laser clad geometry. Three distributions are proposed: Gaussian, uniform and polynomial. In the second model the general form of the clad cross section is supposed to be a disk due to the surface tension forces. Analytical relationships are established between the radius and the center of the disk in one hand and the process parameters in the other hand. This way we show that we can reproduce the laser track geometry in all the area experimentally explored.

International audienceTwo complementary methods were used to analyse the deformation mechanisms involved in the plasticity of commercially pure titanium during compressive loading: neutron diffraction and the self-consistent model. The strain response of 15 crystallographic planes was tracked during the measurement, in directions both parallel and transverse to the straining direction, providing new insight into the mechanical behaviour of the polycrystal. The neutron diffraction results show evidence of tensile twins in the titanium alloy studied. The twin volume fraction was determined from the change in crystallographic texture. The influence and the role of plastic anisotropy were also studied and explained in this work. Good agreement was found between the experimental and predicted results