Nitrogen (N) fertilizers are one of the most expensive inputs in agricultural settings. Additionally, the loss of N increases costs, contributes to soil acidification, and causes off-site pollution of the air, groundwater and waterways. This study reviews current knowledge about technologies for N fertilization with potential to increase N use efficiency and reduce its negative effects on the environment. Classic inorganic sources such as urea and ammonium sulfate are the major sources utilized, while controlled N release fertilizers have not been significantly adopted for cereals and oil crops. Microorganisms, with the exception of Rhizobium sp. in soybeans, are also not widely used nowadays (e.g., plant growth-promoting bacteria and cynobacteria). The interest in implementing new N fertilization knowledge is stimulating the development of sensors to diagnose the N status and decision support systems for integrating several variables to optimize sources, rates and methods of application. Among potential new technologies we identified the incipient development of nanofertilizers, nutrient formulations to coat seeds, and recycled nutrients. Furthermore, increasing concern about the environmental consequences of N may facilitate the implementation of innovations outside the farm such as more effective regulations to guide N fertilization and methods to manufacture N fertilizers that are more energy-efficient and less CO 2 equivalent emitting.

The quality of biofertilizers is usually assessed only in terms of the amount of nutrients that they supply to the crops and their lack of viable pathogens and phytotoxicity. The goal of this study was to determine the effectiveness of a liquid biofertilizer obtained from rabbit manure in terms of presence of pathogens, phytotoxicity, and its effect on the grain yield and other agronomic traits of barley (Hordeum vulgare L.). Environmental effects of the biofertilizer were also evaluated by following its influence on selected soil parameters. We applied the biofertilizer at five combinations of doses and timings each and in two application modes (foliar or direct soil application) within a randomized complete block design with three replicates and using a chemical fertilizer as control. The agronomic traits evaluated were plant height, root length, dry weight, and number of leaves and stems at three growth stages: tillering, jointing, and flowering. The effectiveness of the biofertilizer was significantly modified by the mode of application, the growth stage of the crop, and the dose of biofertilizer applied. The results showed that the foliar application of the biofertilizer at the tillering stage produced the highest increase in grain yield (59.7 %, p < 0.10). The use of the biofertilizer caused significant changes in soil, particularly concerning pH, EC, Ca, Zn, Mg, and Mn. It is our view that the production and use of biofertilizers are a reliable alternative to deal with a solid waste problem while food security is increased.

BACKGROUND: The environmental risk from the application of synthetic chelates has led to the use of biodegradable complexes to correct Fe deficiency in plants. In this article, the Fe oxidation state, the Fe:ligand ratio, and the molecular weight distribution for heptagluconate (G7) and gluconate (G6) are considered as key factors for the efficacy of complexes as fertilizers. Complexes with different Fe:ligand ratios were prepared and analyzed by gel filtration chromatography (GFC). The ability of Fe:ligand ratios to provide Fe to tomato in hydroponics and soybean in calcareous soil was tested and compared with synthetic chelates (Fe 3+ :HBED and Fe 3+ :EDTA). RESULTS: G7 presented greater capacity to complex both Fe(II) and Fe(III) than G6, but the Fe(II) complexes exhibited poor stability at pH 9 and oxidation in solution.Gel filtration chromatography demonstrated the polynuclear nature of the Fe 3+ :G7 at various ratios. The effectiveness of the Fe fertilizers depend on the Fe 3+ :ligand ratio and the ligand type, the Fe 3+ :G7 (1:1 and 1:2) being the most effective. Fe 3+ :G7 (1:1) also presented a better response for the uptake of other micronutrients. CONCLUSION: Fe 3+ :G7 molar ratios have been shown to be critical for plant Fe uptake under hydroponic conditions and with calcareous soil. Thus, the Fe 3+ :G7 at equimolar ratio and 1:2 molar ratio can be an environmentally friendly alternative to less degradable synthetic chelates to correct Fe chlorosis in strategy I plants.

No abstract

Waste Opuntia is an abundant source of biomass to produce biogas and biofertilizer in a small and commercial scale. This crop has a high biomass yield, wide adaptation to diverse climatic zones, rapid growth, and low input requirements. This study aimed to evaluate the combined effect of adjusting C/N ratio and an alkaline pretreatment (AP) of waste Opuntia heliabravoana Scheinvar in the production of biogas and biofertilizer in anaerobic reactors. AP bioreactors produced more biogas than the control (C, without the combined effect of AP); besides, in this process, it was not necessary to use additional water due to the high content of water that is present in the tissue of this crop. On the other hand, both biofertilizers (C and AP) had enssential microbial groups that help to enhance plant nutrition as S-reducers, S-oxidizers, amylolytic, cellulolytic bacteria, anaerobic S-mineralizers, cellulolytic fungi, and P-solubilizers. Also, the AP treatment to help to increase 1.5:1 total nitrogen (TN) concentration decreased the pathogenic microorganisms in the biofertilizer compared to the C treatment. For this reason, Opuntia spp. is a good substrate for production of biogas and biofertilizer with essential nutrients for many crops in area with water scarcity.

BACKGROUND The environmental risk of the application of synthetic chelates has furthered the implementation of biodegradable complexes to correct manganese (Mn)‐deficient plants. This study used the biodegradable ligands of heptagluconate (G7) and gluconate (G6) to test the influence of the Mn2+:ligand ratio on their fertilizers' capacity to provide Mn to plants. The efficacy of these complexes to correct Mn‐deficient soybean was evaluated in hydroponics and calcareous soil conditions and compared with the synthetic chelate EDTA (ethylenediaminetetraacetic acid). RESULTS This study demonstrated that G7 was a biodegradable alternative to EDTA for supplying Mn, maintaining an adequate nutritional balance compared with G6, which reduced iron (Fe) uptake by the plants. The efficacy of the Mn complexes depended on both the ligand and the Mn:ligand ratio, with the 1:1 and 1:2 molar ratios of Mn2+:G7 being the most effective complexes in the short term on the basis of their chemical structure and stability. CONCLUSION The Mn2+:G7 (1:1 and 1:2) complexes were found to be effective Mn sources for plant nutrition due to their chemical structures providing adequate stability in alkaline solution and their fast‐action effect. © 2021 Society of Chemical Industry