This paper presents a study about polypropylene-pine wood composites, both as filaments and products, coated with aluminum (Al) or copper (Cu), obtained through flame thermal spray process after subjecting the composites to thermal treatments in the second and third step of the study. Results revealed that a previous aluminum layer was needed in order to obtain copper coatings on the composites. The physical and mechanical properties of both metal coated composite filaments were also evaluated and compared with the uncoated composite filaments with and without heat treating these. Consequently, it was observed that the nature of the coating adhesion on the substrates was mechanical, and therefore abrasion blasting of filaments or the use of a higher wood fiber content in the composite improved the Al or Cu adhesion. Also, it was observed that extruded wood fiber/PP filaments should not be cooled in water because pieces might be molded directly once the moisture affects the metal coatings adhesion onto the substrates.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.