Effects of ractopamine hydrochloride (RH) and zilpaterol hydrochloride (ZH) on saleable yield of carcass sides from calf-fed Holstein steers were evaluated using steers implanted with a progesterone (100 mg) plus estradiol benzoate (10 mg) implant followed by a terminal trenbolone acetate (200 mg) plus estradiol (40 mg) implant. Steers were blocked by weight into pens (n = 32) randomly assigned to one of four treatments: control, RH fed at 300 mg•steer(-1)/d(-1) (RH 300) or RH fed at 400 mg•steer(-1)/d(-1) (RH 400) the final 31 d of finishing, and ZH fed at 60 to 90 mg•steer(-1)/d(-1) (7.56 g/ton on a 100% DM basis) for 21 d with a 5 d withdrawal before harvest. Eight to nine carcass sides were randomly selected from each pen; carcass sides with excessive hide pulls, fat pulls or bruises were avoided. Cutout data were collected within a commercial facility using plant personnel to fabricate sides at a rate of one every 3 to 4 min into items typically merchandised by the facility. All lean, fat and bone were weighed and summed back to total chilled side weight with a sensitivity of ± 2% to be included in the data set. Compared to controls, β-agonists increased saleable yield of whole-muscle cuts by 0.61%, 0.86% and 1.95% for RH 300, RH 400 and ZH, respectively (P < 0.05). Percent fat was less in carcasses from the ZH treatment compared to controls (P < 0.05); however, this difference was not observed between RH treatments and controls (P > 0.05). Percent bone was less in the ZH treatment due to increased muscle (P < 0.05). The percent of chilled side weight comprised of trimmings was unchanged between treatments, but on a 100% lean basis, RH 400 and ZH increased trim yields (P < 0.05). Analysis of saleable yield by primal showed a fundamental shift in growth and development. Beta-agonists caused a shift in proportion of saleable yield within individual primals, with a greater portion produced from the hindquarter relative to the forequarter, specifically in those muscles of the round (P < 0.05). Beta-agonists increased saleable yield, but these effects were not constant between all major primals. The cutout value gained by packers as a result of β-agonist use may be influenced more by reduced fatness and increased absolute weight if musculature is primarily increased in the lower priced cuts of the carcass.
British × Continental steers (initial BW = 484.6 kg) were fed at a commercial feed yard to evaluate the effects of β-agonists on live performance, carcass characteristics, and carcass subprimal yield. Weights and ultrasonic measurements were used to allocate steers to pens (n = 40) divided equally into 4 blocks, with 2 treatment replicates per block. Pens were randomly assigned to 1 of 5 treatments: control; ractopamine-HCl (RH) fed at 200 or 300 mg • steer(-1) • d(-1), or 400 mg • steer(-1) • d(-1) top dress for the final 30 d of feeding; or zilpaterol-HCl (ZH) fed at 7.5 mg/kg beginning 23 d before slaughter with a 3-d withdrawal period. Steers were harvested by block at a commercial facility over 4 wk. Carcass based performance measures were calculated using initial pen weights and actual DMI. From each pen, eight carcasses that were within ± 13.6 kg of the mean pen HCW were selected such that two carcasses were within each of the following four Yield Grade (YG) ranges: YG ≤ 2.8; 2.9-3.2; 3.3-3.5; YG > 3.5. Carcasses were fabricated by plant personnel to determine subprimal yield. Steers fed ZH had higher carcass-based ADG and carcass-based G:F compared with all other treatments (P < 0.05). Carcass-based ADG and carcass-based G:F were higher in RH treatments compared with controls (P < 0.05). Steers fed ZH had higher dressing percentages (1.0 to 1.6%) and larger LM area (4.3 to 6.7 cm(2)) than all other treatments (P < 0.05). Use of RH 400 and ZH increased HCW 6.3 and 11.1 kg, respectively compared with controls (P < 0.05). Compared with controls, RH 300 and ZH decreased marbling score and the frequency of carcasses qualifying for upper 2/3 Choice premiums (P < 0.05). Beta-agonists increased subprimal yield from the round and loin; however, blade meat was the only cut from the rib or chuck affected by β-agonists. Results from this study indicated improvements in performance and carcass traits as a result of β-agonist use; however, differences between ZH, RH 400, and RH 300 treatments were minimal for carcass traits and cutability. Increases in saleable yield following β-agonist use were not uniformly distributed across the four major primals and the majority of weight gain occurred in the lower priced cuts of the round and chuck. Increased response of the lower priced cuts to β-agonists could have economic implications to packers.
Effect of ractopamine hydrochloride (RH) and zilpaterol hydrochloride (ZH) on LM shear force and sensory attributes was determined using pens (n = 40) British × Continental crossbred steers randomly allocated to one of the following treatments: control; RH fed at 200 (RH 200) or 300 mg • steer(-1) • d(-1) (RH 300), or 400 mg • steer(-1) • d(-1) (RH 400) top-dressed for the final 30 d of feeding; or ZH fed at 7.5 mg/kg, beginning 23 d before slaughter with a 3-d withdrawal. Two replicates (pens) per treatment were represented in four blocks. Eighteen carcasses per pen were randomly selected and one 5-cm LM sample was removed from both carcass sides to be used for shear force and sensory evaluation. Samples were aged for 14 d, frozen at -28.8 °C, and cut into 2.5-cm steaks. All steaks were cooked to an internal temperature of 71.1 °C before being evaluated for Warner-Bratzler shear force (WBSF), slice shear force (SSF), or being fed to trained sensory panelists. Increasing dose and potency of β-agonist increased WBSF by 4 to 17% and SSF by 5 to 24% (P < 0.05). Steaks from steers fed ZH had higher WBSF and SSF values compared with all other treatments (P < 0.05), whereas steaks from controls and steers fed RH 200 were not different (P > 0.05). Probability of steaks failing to meet shear force standards to be certified tender (WBSF <4.4 kg, SSF < 20 kg) was increased from an initial probability of <0.06 in steaks from steers in the control treatment to 0.10 to 0.20 in steers fed RH 400 or ZH (P < 0.05). No difference was detected in panel ratings for overall tenderness of steaks from steers fed RH 200 compared with controls (P > 0.05). Steaks from steers fed RH 300 and RH 400 were comparable for all sensory attributes; however, both RH 300 and RH 400 were rated lower for overall tenderness than controls (P < 0.05). Panelists failed to detect differences in overall tenderness of steaks from steers fed RH 400 and ZH (P < 0.05). Panelists detected no difference in flavor profile or juiciness among treatments (P > 0.05). Results from this study indicated β-agonists negatively affected beef tenderness and these effects may be more noticeable in steers supplemented with ZH and higher doses of RH.
A survey was conducted from November 2009 to April 2010 to determine how importers of pork define 7 predetermined quality categories (food safety, customer service, eating quality, product specification, packaging, visual characteristics, and production history) and to estimate willingness-to-pay (WTP) and establish best-worst (B/W) scaling (rank) for the 7 quality categories. Interviews were conducted in Hong Kong/China (n = 83), Japan (n = 48), Mexico (n = 70) and Russia (n = 54) with importers of U.S. pork or those who had purchased U.S. pork from distributors in the last 3 yr. Interviews used dynamic routing software and were structured such that economic factors for purchase were addressed first, allowing all responses to focus on quality. Questions about WTP and B/W were asked and then each respondent was asked to define what each quality category meant to them. Generalized linear mixed models were used to analyze frequency data. Over 70% of interviewees in Hong Kong/China, Japan, and Mexico responded that purchase price was influential in deciding whether or not to purchase imported pork. This number was lower in Russia, where respondents stated tariff rates were also important, indicating market access was a larger issue in Russia. Food safety was the most important quality category (price was not included as a part of quality) for imported pork followed by specifications. Respondents indicated some form of government inspection was how they defined food safety, whereas product size, weight, and subcutaneous fat were all included in the definition of specifications. Interviewees were more likely to pay premiums for customer service and less likely to pay premiums for packaging (P < 0.05). The premiums that were willing to be paid for guarantees of quality for imported pork variety meats were numerically lower than for whole muscle cuts or processed products. A guarantee associated with food safety of processed pork products was found to be the quality attribute for which importers would be willing to pay the highest premium. Production history was found to be the least important quality attribute for importers of all types of U.S. pork, except those in Japan. Exporters could increase profitability if a guarantee of customer service was made. Price, tariffs, and exchange rates are important to pork importers; these results indicated that if certain quality attributes could be guaranteed, exporters could increase profitability.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.