No abstract

No abstract

No abstract

No abstract

We successfully deposited a three dimensional (3D) mesoporous ZnO nanostructure on a glass substrate by using a hydrothermal method, and tested the material for its gas sensing performance.

Barium titanate (BaTiO 3 ) thin films have been prepared using the spray pyrolysis method. The films were deposited onto a glass substrate at varying substrate temperature ranging from 250 to 350°C with the interval of 50°C. The structural, morphological, electrical and dielectric properties of the deposited films have been studied. The X-ray diffraction pattern confirmed the polycrystalline nature of the films with a cubic crystal structure. X-ray photoelectron spectroscopy (XPS) showed a good agreement of the thin films stoichiometry with BaTiO 3 . A presence of Ba, Ti and O in the BaTiO 3 thin films was observed by energy dispersive X-ray analysis. The scanning electron microscopy (SEM) showed the heterogeneous distribution of cubical grains all over the substrate. The grain size decreased with an increase in substrate temperature. The dielectric constant and dielectric loss showed the dispersion behaviour as a function of frequency, measured in the frequency range of 20 Hz to 1 MHz. The AC conductivity (σ ac ) measurement showed the linear nature of obtained films, which confirms conduction mechanism due to small polarons. Impedance spectroscopy has been used to study the electrical behaviour of BaTiO 3 ferroelectric thin films. The ferroelectric hysteresis loop has been recorded at room temperature.

No abstract

No abstract