We present the first GPS‐derived geodetic observations from the NE end of the Eastern Betic Shear Zone obtained from the Bajo Segura GPS network (SE Spain). The network has 11 GPS sites and was sampled four times between 1999 and 2013. Despite the low signal‐to‐noise ratio of the residual velocities obtained, the velocities are nonzero at 95% confidence level. We postulate that the GPS data point to the partitioning of deformation into the NNW–SSE shortening and a N70E left‐lateral component. The maximum deformation rates are located along the two main active faults in the study area. The maximum shortening rates (north component) in the southern region of the Bajo Segura Basin vary from west to east, ranging from 0.2 to 0.7 mm/year along the Bajo Segura Fault Zone. On the northern border of the basin, along the Crevillente Fault Zone, left‐lateral displacement varies between 0.4 and 0.7 mm/year in the E‐W direction. The GPS‐based regional geodynamic models of the Western Mediterranean indicate that the residual shortening of the Eurasia‐Nubia plate convergence is accommodated in the eastern part of the Iberian Peninsula and the Algero‐Balearic Basin. Our results indicate that part of this residual deformation occurs at the NE end of the Eastern Betic Shear Zone, but significant deformation must be accommodated also to the north (External Betics) and to the south (Cartagena Basin and offshore area). We postulate that Eurasia‐Nubia plate convergence is transferred to the Eastern Betics because of the thin and rigid (potentially oceanic) crust of the Algero‐Balearic Basin, which acts as an indenter.
The characterization of soil is essential for the evaluation of seismic hazard, because soil properties strongly influence the damage caused by earthquakes. Methods based on seismic noise are the most commonly used in soil characterization. Concretely, methods based on seismic noise array measurements allow for the estimation of Rayleigh wave dispersion curves and, subsequently, shear-wave velocity profiles. The equipment required for the application of this technique is usually very expensive, which could be a significant economic challenge for small research groups. In this work, we have developed a wireless multichannel seismic noise recorder system (Geophonino-W), which is suitable for array measurements. Each station includes a microcontroller board (Arduino), a conditioning circuit, an Xbee module, an SD card, and a GPS module. Several laboratory tests were carried out in order to study the performance of the Geophonino-W: A frequency response test (impulse response and noise); synchronization test; and battery duration test. Comparisons of Geophonino-W with the commercial systems and field measurements were also carried out. The estimated dispersion curves obtained using the proposed system were compared with the ones obtained using other commercial equipment, demonstrating the effectiveness of Geophonino-W for seismic noise array measurements. Geophonino-W is an economic open-source and hardware system that is available to any small research group or university.
The commercial data acquisition systems used for seismic exploration are usually expensive equipment. In this work, a low cost data acquisition system (Geophonino) has been developed for recording seismic signals from a vertical geophone. The signal goes first through an instrumentation amplifier, INA155, which is suitable for low amplitude signals like the seismic noise, and an anti-aliasing filter based on the MAX7404 switched-capacitor filter. After that, the amplified and filtered signal is digitized and processed by Arduino Due and registered in an SD memory card. Geophonino is configured for continuous registering, where the sampling frequency, the amplitude gain and the registering time are user-defined. The complete prototype is an open source and open hardware system. It has been tested by comparing the registered signals with the ones obtained through different commercial data recording systems and different kind of geophones. The obtained results show good correlation between the tested measurements, presenting Geophonino as a low-cost alternative system for seismic data recording.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.