This study was designed to test the ability of a virtual reality dental simulator to predict the performance of students in a traditional operative dentistry manikin course. Twenty-six dental students were pre-tested on the simulator, prior to the course. They were briefly instructed and asked to prepare 12 class I cavities which were automatically graded by the simulator. The instructors in the manikin course that followed were unaware of the students' performances in the simulator pre-test. The scores achieved by each student in the last six simulator cavities were compared to their final comprehensive grades in the manikin course. Class standing of the students in the simulator pre-test positively correlated with their achievements in the manikin course with a correlation coefficient of 0.49 (P = 0.012). Eighty-nine percent of the students in the lower third of the class in the pre-test remained in the low performing half of the class in the manikin course. These results indicate that testing students in a dental simulator, prior to a manikin course, may be an efficient way to allow early identification of those who are likely to perform poorly. This in turn could enable early allocation of personal tutors to these students in order to improve their chances of success.

No abstract

Restoration of tooth surfaces with materials that inhibit formation of heavy bacterial plaque accumulations could be important in the treatment of patients with existing oral disease or in reducing the likelihood for periodontal disease. Captek is a dental gold composite material used to produce copings for ceramometal restorations that has been reported to inhibit plaque accumulation. In this study, the oral bacteria of nine periodontally healthy subjects with a total of 42 gold composite copings were sampled. Contralateral teeth with normal tooth surfaces were also sampled as controls. The quantitative presence of forty bacteria was determined in each sample by DNA:DNA hybridization. The results indicated that the porcelain/gold composite alloy coping surfaces had significantly fewer bacteria than the control normal tooth surfaces (71% reduction). The percentage composition, however, did not differ significantly between surfaces.

Three Class V cavity configurations with walls above and below the cemento-enamel junction were compared when 'sandwich' technique restorations with glass ionomer and composite resin were used. No dye penetration occurred at the occlusal cavosurface margin when the latter was bevelled and light-cured Scotchbond was applied to the etched enamel before restoration with Durafil composite resin. The least dye penetration at the gingival margin was observed when Ketac bond glass ionomer covered the entire non-bevelled wall. No configuration entirely eliminated dye penetration at the gingival margin.

No abstract