This is the second in a two-part paper series dealing with sea salt transportation and deposition mechanisms, and discussing the serious issue of degradation of outdoor insulators resulting from various environmental stresses and severe saline contaminant accumulation near the shoreline. The deterioration rate of outdoor insulators near the shoreline depends on the concentration of saline in the atmosphere, influence of wind speed on the production of saline water droplets, moisture diffusion and saline penetration on the insulator surface. This paper comprises two parts. The first part, deals with the impact of different environmental stresses on insulator surface degradation, including wind speed and direction, cold fog and rainfall. The second part concerns the flashover process related to saline contamination of the surface under constant and variable cold fog wetting rates and equivalent salt deposit density (ESDD). The experiments were performed on high voltage insulators based on the model presented in Part-I. Based on the proposed model, the influence of wind speed and direction on the pollution accumulation rate and impact of wetting rate on discharge current and surface flashover process were investigated. The equations S=S 0 e (Vdep0/αh) [e (αx/v)-1 ] and D=D 0 e (Vdep0/αh) [e (-αx/v)-1 ] are derived from the model for saline concentration and deposition show good reliability and well represent the results obtained. Test results also show that due to the different wetting and contamination deposition rate, surface discharge current characteristics of tested insulator in rain are different with that in cold fog, which lead to different surface flashover voltages. An experimental setup was mounted for artificial saline contamination deposition. The proposed model can be therefore used to investigate insulator flashover near coastal areas and for mitigating saline flashover incidents.
In this paper, some of the characteristics of an arc propagating over an ice-covered insulator surface were investigated. Special attention was paid to the arc root and channel characteristics. All experiments were performed on a simplified physical model to simulate real ice-covered insulators. From the obtained results, based on a set of time-resolved measurements of a surface discharge, some important characteristics, namely arc foot geometry and channel diameter were observed. Possible mechanisms controlling these variations are discussed. An empirical model, accounting for arc propagation pattern on an ice surface, is proposed. The paper contains a substantial amount of new material with a view of closing some major gaps in the present state of knowledge of ice surface flashover.
Abstract:The aim of this paper is to investigate the various effects of climate conditions on outdoor insulators in coastal areas as a result of saline contamination under acidic and normal cold fog, determining significant electrical and physico-chemical changes on the insulator surface and considering the effect of discharge current, electric field distribution and surface roughness. To replicate similar conditions near the shoreline, experimental investigations have been carried out on insulation materials with the combined application of saline contamination and acidic or normal cold fog. The test samples included silicone rubber (SiR), ethylene propylene diene monomer (EPDM) and high-density polyethylene (HDPE), which were used as reference. The materials are of the same composition as those used in real-life outdoor high voltage insulators. All samples were aged separately in an environmental chamber for 150 h for various saline contaminations combined with acidic and normal cold fog, and were generated by means of the adopted experimental setup. This analysis represented conditions similar to those existing near the shoreline exposed to saline and acid spray during winter and early spring. Electric field and discharge current along polymeric samples were examined under acidic and normal cold fog. Fourier transform infrared (FTIR) spectroscopy and scanning electron microscopic (SEM) were used to probe the physico-chemical changes on the samples surface and investigate the hydrophobicity recovery property after aging tests. Finally, a comparative study was carried out on polymeric samples before and after being exposed to the acidic and normal cold fog based on the results obtained from the experiment. Research data may provide references for the better prediction of surface degradation as well as for the better material coating and design of external insulation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.