No abstract

The objective was to investigate the effect of various doses and durations of ractopamine hydrochloride (RAC) on pig HCW, cutting yields, and meat quality. Late-finishing pigs (approximately 93 kg) were allotted to 12 treatments 35 d before slaughter. Treatments consisted of negative control (NEG; 13.1% CP, 0.64 TID Lys), positive control (POS; 17.8% CP, 0.94 TID Lys), and 2 RAC doses (5 and 7.4 mg/kg) with 5 different feeding durations for each dose (7, 14, 21, 28, or 35 d). Pigs on ractopamine-duration diets were fed NEG until incorporation of RAC, and then the diet was switched to POS to comply with label requirements. A subset of 240 pigs was utilized to determine the effects of RAC on carcass cutting yields. This subset was selected by taking the 5 pigs closest to the average pen weight from 4 complete replicates. Differences in response to RAC between 5 and 7.4 mg/kg were not significant. Therefore, RAC dosages were pooled, resulting in an average dose of 6.2 mg/kg, which was then compared with NEG and POS diets. Ractopamine increased (P < 0.05) HCW by 2.5 and 2.3 kg compared with the NEG and POS diets, respectively. Hot carcass weight also increased linearly (P=0.003) as RAC duration increased. Indicators of carcass leanness increased with RAC compared with NEG. Estimated carcass lean percentage increased (P=0.010) 1 percentage unit from 54.79 to 55.79%, carcass cut yield increased (P<0.001) 1.23 percentage units from 50.61 to 51.84%, and (P=0.006) boneless lean cut yield increased 1.27 percentage units from 36.71 to 37.98%. Ractopamine decreased (P=0.002) subjective marbling scores 0.49 units from the NEG value of 3.0, but RAC did not differ (P=0.203) from POS. Subjective color values and shear force aging curves for RAC were not significantly different from NEG or POS. Overall, RAC had greater responses in carcass weight and cut yield than NEG, and had minimal effects on meat quality.

No abstract

Ractopamine hydrochloride (RAC) has consistently led to an advantage in carcass cutting yields of finishing pigs and remains a common feed additive in US finishing pig diets. Less is known about the effect of RAC on further processing characteristics. Some researchers have reported advantages in ultimate pH of the LM in pigs fed RAC. If a greater ultimate pH was also observed in hams, the increased pH could affect further processing characteristics and lead to better protein interaction and improved textural properties. The objective of this experiment was to determine if RAC-fed pigs yielded hams with a greater ultimate pH, and if so, whether or not that advantage improves textural properties and water retention of further processed hams. Two hundred hams from barrows and gilts fed RAC or control diets were selected based on HCW. Hams were fabricated into 5 separate pieces to determine cutting yields, and 6 muscles were evaluated for ultimate pH. Hams were processed to make cured and smoked hams. Ractopamine increased cutting yields of the whole ham (P < 0.0001), inside (P < 0.01), outside (P < 0.01), and knuckle (P < 0.01) when expressed as a percentage of chilled side weight. Ultimate pH of the rectus femoris, vastus lateralis, and semitendinosus were all 0.06 pH units greater (P < 0.05), the biceps femoris was 0.04 pH units greater (P = 0.02), and the semimembranosus and adductor muscles were 0.03 pH units greater in pigs fed 7.4 mg/kg of RAC when compared with control pigs. Cured hams from RAC-fed pigs were heavier at all stages of production. No differences were detected in binding strengths (P = 0.88) or protein fat-free values (P = 0.13) between RAC (9.06 kg and 20.37) and control hams (9.01 kg and 20.13). Ractopamine increased cutting yields, total weight of cured hams, and ultimate muscle pH. Ractopamine can be fed to pigs to achieve the desired growth characteristic advantages and cutting yields without affecting further processed ham characteristics.

Zilpaterol hydrochloride (ZH) is de signed to increase carcass leanness, chilled side weight (CSW), and percent saleable yield. The objective of this study was to evaluate the effect of a single dose of ZH on cutability and subprimal yield of calf-fed Holstein steers when fed for increasing durations. Two hundred forty steers were fed 8.3 mg/kg of ZH on a DM basis for 0, 20, 30, or 40 d, with a 3-d withdrawal before slaughter. After slaughter, steers were fabricated into 4 pieces (round, loin/flank, rib/plate, and chuck), packaged in combos, shipped to 2 locations, and further fabricated into subprimal pieces and trim. Trim was collected from each primal and separated into groups based on composition of 90, 80, and 50% lean. Zilpater ol hydrochloride increased (P = 0.01) CSW by 6.22 kg and saleable yield by 6.4 kg when included in the diet for 20 d. Furthermore, saleable yield as a percentage of CSW was increased (P = 0.03) 1.18 percentage units when included in the diet for 20 d. Steers fed ZH for 20 d had heavier strip loins (4.47 vs. 4.12 kg, P = 0.02), tenderloins (2.75 vs. 2.49 kg, P = 0.02), and ribeye rolls (5.74 vs. 5.30 kg, P = 0.01) than steers not fed ZH. These advantages are further demonstrated as a per centage of CSW. Strip loins (P = 0.06), tenderloins (P = 0.04), and ribeye rolls (P = 0.04) of ZH-fed steers had a greater percentage of CSW than controls. Zilpaterol hydrochloride also increased the percentage of CSW of the 3 primary components of the round when fed for 20 d. The knuckle was 0.10 percentage units heavier (P = 0.11), the top round was 0.24 percentage units heavier (P = 0.04), and the bottom round was 0.22 percentage units heavier (P = 0.03) in ZH-fed steers when com pared with steers not fed ZH. Based on these data, it can be concluded that ZH significantly increased subprimal cutting weights, yields, and percentage saleable yield of calf-fed Holstein steers when fed for at least 20 d before slaughter. Zilpaterol hydrochloride increased percentage of CSW of subprimal cuts from Holstein steers in the round and to a lesser degree in the loin.