This study analyzed the influence of electrode geometry, tissue-electrode angle, and blood flow on current density and temperature distribution, lesion size, and power requirements during radio-frequency ablation. We used validated three-dimensional finite element models to perform these analyses. We found that the use of an electrically insulating layer over the junction between electrode and catheter body reduced the chances of charring and coagulation. The use of a thermistor at the tip of the ablation electrodes did not affect the current density decreased more slowly with distance from the electrode surface. We analyzed the effects of three tissue-electrode angles: 0, 45, and 90 degrees. More power was needed to reach a maximal tissue temperature of 95 degrees C after 120 s when the electrode-tissue angle was 45 degrees. Consequently, the lesions were larger and deeper for a tissue-electrode angle of 45 degrees than for 0 and 90 degrees. The lesion depth, volume, and required power increased with blood flow rate regardless of the tissue-electrode angle. The significant changes in power with the tissue-electrode angle suggest that it is safer and more efficient to ablate using temperature-controlled RF generators. The maximal temperature was reached at locations within the tissue, a fraction of a millimeter away from the electrode surface. These locations did not always coincide with the local current density maxima. The locations of these hottest spots and the difference between their temperature and the temperature read by a sensor placed at the electrode tip changed with blood flow rate and tissue-electrode angle.
We developed a temperature-controlled radiofrequency (RF) system which can ablate by delivering energy to up to six 12.5 mm long coil electrodes simultaneously. Temperature feedback was obtained from temperature sensors placed at each end of coil electrodes, in diametrically opposite positions. The coil electrodes were connected in parallel, via a set of electronic switches, to a 150 W 500 kHz temperature-controlled RF generator. Temperatures measured at all user-selected coil electrodes were processed by a microcontroller which sent the maximum value to the temperature input of the generator. The generator adjusted the delivered power to regulate the temperature at its input within a 5 degrees C interval about a user-defined set point. The microcontroller also activated the corresponding electronic switches so that temperatures at all selected electrodes were controlled within a 5 degrees C interval with respect to each other. Physical aspects of tissue heating were first analysed using finite element models and current density measurements. Results from these analyses also constituted design input. The performance of this system was studied in vitro and in vivo. In vitro, at set temperatures of 70 degrees C, 85% of the lesions were contiguous. All lesions created at set temperatures of 80 and 90 degrees C were contiguous. The lesion length increased almost linearly with the number of electrodes. Power requirements to reach a set temperature were larger as more electrodes were driven by the generator. The system impedance decreased as more electrodes were connected in the ablation circuit and reached a low of 45.5 ohms with five coil electrodes in the circuit. In vivo, right atrial lesions were created in eight mongrel canines. The power needed to reach 70 degrees C set temperature varied between 15 and 114 W. The system impedance was 105+/-16 ohms, with one coil electrode in the circuit, and dropped to 75+/-12 ohms when two coil electrodes were simultaneously powered. The length and the width of the lesion set varied between 17.6+/-6.1 and 59.2+/-11.7 mm and 5.9+/-0.7 and 7.1+/-1.2 mm respectively. No sudden impedance rises occurred and 75% of the lesions were contiguous. From the set of contiguous lesions, 90% were potentially therapeutic as they were transmural and extended over the entire target region. The average total procedure and fluoroscopy times were 83.4 and 5.9 min respectively. We concluded that the system can safely perform long and contiguous lesions in canine right atria.
Transcatheter subendocardial infusion can be used to reversibly impair local excitability and mark an injection site fluoroscopically. Subendocardial injection of ethanol can predictably ablate a large volume of ventricular myocardium. Additional study of this system in an arrhythmia model will help to define its potential for mapping and ablation of hypotensive ventricular tachycardia.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with đź’™ for researchers
Part of the Research Solutions Family.