Abstract. We present initial validation results of the space-borne lidar CALIOP onboard CALIPSO satellite using coincidental observations from a ground-based lidar in Seoul National University (SNU), Seoul, Korea (37.46 • N, 126.95 • E). We analyze six selected cases between September 2006 and February 2007, including 3 daytime and 3 night-time observations and covering different types of clear and cloudy atmospheric conditions. Apparent scattering ratios calculated from the two lidar measurements of total attenuated backscatter at 532 nm show similar aerosol and cloud layer structures both under cloud-free conditions and in cases of multiple aerosol layers underlying semitransparent cirrus clouds. Agreement on top and base heights of cloud and aerosol layers is generally within 0.10 km, particularly during night-time. This result confirms that the CALIPSO science team algorithms for the discrimination of cloud and aerosol as well as for the detection of layer top and base altitude provide reliable information in such atmospheric conditions. This accuracy of the planetary boundary layer top height under cirrus cloud appears, however, limited during daytime. Under thick cloud conditions, however, information on the cloud top (bottom) height only is reliable from CALIOP (ground-based lidar) due to strong signal attenuations. However, simultaneous space-borne CALIOP and ground-based SNU lidar (SNU-L) measurements complement each other and can be combined to provide full information on the vertical distribution of aerosols and clouds. An aerosol backscatter-to-extinction ratio (BER) estimated from lidar and sunphotometer synergy at the SNU site during the CALIOP overpass is assessed to be 0.023±0.004 sr −1 (i.e. a lidar ratio of 43.2±6.2 sr) fromCorrespondence to: S.-W. Kim (sang-woo.kim@cea.fr) CALIOP and 0.027±0.006 sr −1 (37.4±7.2 sr) from SNU-L. For aerosols within the planetary boundary layer under cloud-free conditions, the aerosol extinction profiles from both lidars are in agreement within about 0.02 km −1 . Under semi-transparent cirrus clouds, such profiles also show good agreement for the night-time CALIOP flight, but large discrepancies are found for the daytime flights due to a small signal-to-noise ratio of the CALIOP data.

[1] The new generation of spaceborne backscatter lidar systems, prefigured by the Lidar in-Space Technology Experiment (LITE) mission in September 1994, will give new insight on the vertical distribution of both aerosols and clouds in the atmosphere. This is especially of importance for aerosols over land, where retrievals from passive sensors are known to be more difficult because of the surface contribution. Here we analyze mineral dust aerosol transport events through a new approach coupling the active LITE and passive Meteosat-5 spaceborne observations. The Meteosat-derived aerosol optical thickness at 550 nm is shown to be a good boundary condition for the lidar inversion in order to retrieve both the aerosol backscatter to extinction ratio (BER) and the aerosol extinction vertical profile above the Tropical Atlantic Ocean (TAO) and the Mediterranean Sea. Sensitivity tests indicate that the aerosol scattering coefficient is retrieved within a 20% relative uncertainty. Air mass trajectories allow us to further retrieve the vertical profile of aerosol optical properties over the continent in the Saharan Heat Low (SHL) region using the BER determined over the ocean. Results confirm a large dispersion of the BER which is not attributed to errors in the method. This shows the need to account for such dispersion in the retrieval of dust aerosol optical thickness and aerosol impact on the earth radiative budget. The coupling between LITE and Meteosat-5 made here is shown to be interesting for an improvement of the direct dust aerosol forcing, and results should be improved by the CALIOP-MODIS synergy.