Local electron and ion heating characteristics during merging reconnection startup on the MAST spherical tokamak have been revealed for the first time using a 130 channel YAG-TS system and a new 32 chord ion Doppler tomography diagnostic. 2D local profile measurement of Te, ne and Ti detect highly localized electron heating at the X point and bulk ion heating downstream. For the push merging experiment under high guide field condition, thick layer of closed flux surface formed by reconnected field sustains the heating profile for more than electron and ion energy relaxation time τ E ei ∼ 4 − 10ms, both heating profiles finally form triple peak structure at the X point and downstream. Toroidal guide field mostly contributes the formation of peaked electron heating profile at the X point. The localized heating increases with higher guide field, while bulk downstream ion heating is unaffected by the change in the guide field under MAST conditions (Bt > 3Brec).PACS numbers: 52.35. Vd, 52.55.Fa, 52.72.+v Magnetic reconnection is a fundamental process which converts the magnetic energy of reconnecting fields to kinetic and thermal energy of plasma through the breaking and topological rearrangement of magnetic field lines. Recent satellite observations of solar flares revealed several important signatures of reconnection heating. In the solar flares, hard X-ray spots appear at loop-tops of coronas together with another two foot-point spots on the photosphere. The loop-top hot spots are considered to be caused by fast shocks formed in the down-stream of reconnection outflow [3]. The two-dimensional (2D) measurements of the Hinode spectrometer documented a significant broadening of Ca line-width downstream of reconnection [4]. These phenomena strongly suggest direct ion heating by reconnection outflow. On the other hand, the V-shape high electron temperature region was found around X-line of reconnection as an possible evidence of slow shock structure [5]. However, those heating characteristics of reconnection are still under serious discussion, indicating that direct evidence for the reconnection heating mechanisms should be provided by a proper laboratory experiment. Since 1986 the merging of two toroidal plasmas (flux tubes) has been studied in a number of experiments: TS-3

A centre-solenoid-free merging start-up scheme for spherical tokamak plasmas was developed in a University of Tokyo spherical tokamak (UTST) experiment by using outer poloidal field coils. Torus breakdown was initiated at null points and two spherical tokamak plasmas with a total current up to 80 kA were generated inductively. Their merging process provided substantial ion and electron heating by magnetic reconnection. The obtained dependence of heating on plasma current suggests that high-temperature and high-current plasma suitable for neutral beam injection is attainable under the realistic conditions in the merging start-up method.

We have proposed a new approach for equilibrium reconstruction that can be applied to ITER-like burning plasmas. In this study, we have focused on carrying out equilibrium reconstruction using polarimetry, which is feasible for ITER-like burning plasmas. Polarimetry in burning plasmas is different from that in the existing tokamaks in two regards: (1) increased importance of the relativistic effects and (2) significant coupling with the Faraday and Cotton–Mouton effects. We found that when polarimetric data (orientation angle, θ, and ellipticity angle, ϵ, of a polarization state) are used as the constraints in the equilibrium reconstruction, the optimum weighting factors for θ and ϵ depend on the magnetic surfaces through which the viewing chord of polarimetry passes. We applied our approach to the operation scenarios II (S2) and IV (S4) in ITER. In the case where the viewing chords are via both the equatorial and upper ports, the measurement requirements for the accuracy of the q-profile in ITER (±10%) were satisfied in S2 and S4 when the measuring errors of θ and ϵ were less than 0.5° and 3°, respectively.

We present results of recent studies of merging/reconnection heating during central solenoid (CS)-free plasma startup in the Mega Amp Spherical Tokamak (MAST). During this process, ions are heated globally in the downstream region of an outflow jet, and electrons locally around the X-point produced by the magnetic field of two internal P3 coils and of two plasma rings formed around these coils, the final temperature being proportional to the reconnecting field energy. There is an effective confinement of the downstream thermal energy, due to a thick layer of reconnected flux. The characteristic structure is sustained for longer than an ion-electron energy relaxation time, and the energy exchange between ions and electrons contributes to the bulk electron heating in the downstream region. The peak electron temperature around the X-point increases with toroidal field, but the downstream electron and ion temperatures do not change.

The University of Tokyo Spherical Tokamak (UTST) was constructed to explore the formation of ultrahighbeta spherical tokamak (ST) plasmas using double null plasma merging. The main feature of the UTST is that the poloidal field coils are located outside the vacuum vessel to demonstrate startup in a reactor-relevant situation. Initial operations used partially completed power supplies to investigate the appropriate conditions for plasma merging. The plasma current of the merged ST reached 100 kA when the central solenoid coil was used to assist plasma formation. Merging of two ST plasmas through magnetic reconnection was successfully observed using two-dimensional pickup coil arrays, which directly measure the toroidal and axial magnetic fields inside the UTST vacuum vessel. The resistivity of the current sheet was found to be anomalously high during merging.