No abstract

ABSTRACT:PAA networks have been prepared by crosslinking copolymerization of acrylamide (AA) and N,N'-methylen-bis-acrylamide (BA) in water. The degree of swelling was measured in the range v2 =0-0.16 as a function of crosslinker proportion, C (%w/w) and total concentration, Cr (g/ I 00 ml). The swelling of two networks with BA contents of 3 ~,;; and I 0% were measured as a function of temperature in the range 10-30°C. The interpretation of elastic and swelling data in terms of the scaling law lfih 1 =Av2 m, shows a transition from a good solvent regime to a collapsed state for the polymer chains, when the crosslinker proportion is around 5 to 7%.

No abstract

No abstract

The influence of graphene nanoplatelets (GNPs) on the curing of an epoxy resin based on diglycidyl ether of bisphenol A (DGEBA) and cross-linked with 4,4'-diaminodiphenylmethane (DDM) was studied. Dynamic mechanical properties and tensile properties of the corresponding graphene/epoxy nanocomposites were obtained. Two compositions 1 and 5 mass% of GNPs were studied. The cross-linking reaction of the epoxy resin is accelerated in dispersions with 5 mass% GNPs. In the presence of GNPs, the curing reaction becomes less exothermic, obtaining less perfect epoxy networks compared to neat epoxy (DGEBA-DDM) thermoset. Accordingly, the glass transition temperatures (T g ) of the nanocomposites are lower than that of the neat epoxy thermoset. This effect is not detected for low content of graphene (1 mass%). Protocol of curing having two isothermal steps leads to more perfect networks than the dynamic curing in the DSC. The Tg reduction is minimized in the samples cured through two isothermal steps. The storage moduli of the nanocomposite containing 5 mass% graphene, both in the glassy (T < T g ) and the rubbery (T > T g ) states, are higher than the ones of neat epoxy thermoset, being most pronounced this effect at T > T g . Tensile tests confirmed the higher elastic moduli of the nanocomposites; however, a decrease in strain at break and tensile strength was observed for the nanocomposite containing 5 mass% of GNPs. This brittle behavior is consistent with the morphology of the samples studied by scanning electron microscopy.

No abstract

No abstract

No abstract