Fluorination can alter the electronic properties of graphene and activate sites for subsequent chemistry. Here, we show that graphene fluorination depends on several variables, including XeF2 exposure and the choice of substrate. After fluorination, fluorine content declines by 50-80% over several days before stabilizing. While highly fluorinated samples remain insulating, mildly fluorinated samples regain some conductivity over this period. Finally, this loss does not reduce reactivity with alkylamines, suggesting that only nonvolatile fluorine participates in these reactions.

No abstract

A sharp tip of atomic force microscope is employed to probe van der Waals forces of a silicon oxide substrate with adhered graphene. Experimental results obtained in the range of distances from 3 to 20 nm indicate that single-, double-, and triple-layer graphenes screen the van der Waals forces of the substrate. Fluorination of graphene, which makes it electrically insulating, lifts the screening in the single-layer graphene. The van der Waals force from graphene determined per layer decreases with the number of layers. In addition, increased hole doping of graphene increases the force. Finally, we also demonstrate screening of the van der Waals forces of the silicon oxide substrate by single- and double-layer molybdenum disulfide.

This work demonstrates the production of a well-controlled, chemical gradient on the surface of graphene. By inducing a gradient of oxygen functional groups, drops of water and dimethyl-methylphosphonate (a nerve agent simulant) are "pulled" in the direction of increasing oxygen content, while fluorine gradients "push" the droplet motion in the direction of decreasing fluorine content. The direction of motion is broadly attributed to increasing/decreasing hydrophilicity, which is correlated to high/low adhesion and binding energy. Such tunability in surface chemistry provides additional capabilities in device design for applications ranging from microfluidics to chemical sensing.

We demonstrated the fabrication of graphene nanoribbons (GNRs) as narrow as 35 nm created using scanning probe lithography to deposit a polymer mask(1-3) and then fluorinating the sample to isolate the masked graphene from the surrounding wide band gap fluorographene. The polymer protected the GNR from atmospheric adsorbates while the adjacent fluorographene stably p-doped the GNRs which had electron mobilities of ∼2700 cm2/(V·s). Chemical isolation of the GNR enabled resetting the device to nearly pristine graphene.