With the increasing demand for energy consumption in domestic buildings and consequent CO 2 emission, there is a need to provide proper products to reduce energy loss. Domestic radiators for space heating can be improved by using a Compact Latent Heat Storage (CLHS) unit mounted on the wall side surface in order to offer energy saving and peak-shaving. The unit offers the potential to save otherwise wasted energy from the back surface of the radiator to the walls in the charging mode of the energy storage system. When the heating system is turned off, the CLHS unit discharges the stored heat towards the room to provide a uniform temperature on the surface of the radiator. An aluminium foam embedded inside the bulk Phase Change Material (PCM) can modify the heat storage/retrieval rate. A PCM is selected depending on the radiator's surface temperature, which is almost equal to the hot water temperature delivered to the radiator. Different metal foam porosities are examined and compared with the PCM-only alternative (i.e. without metal foam enhancement). The results show the porous-PCM CLHS alternative provides an almost constant temperature during the discharging process equal to 54°C. However, for the PCM-only alternative, the temperature of the surface reduces continuously. Using the porous medium results in a shorter melting time, about 95% of what is needed for the PCM-only alternative. Increasing the metal foam porosity results in shorter charging/discharging time; however, since the surface temperature of the porous-PCM unit is almost constant for different metal foam porosities, a system with higher porosity (97%) is desirable.

No abstract

Applying a well-performing heat exchanger is an efficient way to fortify the relatively low thermal response of phase-change materials (PCMs), which have broad application prospects in the fields of thermal management and energy storage. In this study, an improved PCM melting and solidification in corrugated (zigzag) plate heat exchanger are numerically examined compared with smooth (flat) plate heat exchanger in both horizontal and vertical positions. The effects of the channel width (0.5 W, W, and 2 W) and the airflow temperature (318 K, 323 K, and 328 K) are exclusively studied and reported. The results reveal the much better performance of the horizontal corrugated configuration compared with the smooth channel during both melting and solidification modes. It is found that the melting rate is about 8% faster, and the average temperature is 4 K higher in the corrugated region compared with the smooth region because of the large heat-exchange surface area, which facilitates higher rates of heat transfer into the PCM channel. In addition to the higher performance, a more compact unit can be achieved using the corrugated system. Moreover, applying the half-width PCM channel accelerates the melting rate by eight times compared to the double-width channel. Meanwhile, applying thicker channels provides faster solidification rates. The melting rate is proportional to the airflow temperature. The PCM melts within 274 s when the airflow temperature is 328 K. However, the melting time increases to 460 s for the airflow temperature of 308 K. Moreover, the PCM solidifies in 250 s and 405 s in the cases of 318 K and 328 K airflow temperatures, respectively.

No abstract

No abstract

No abstract

No abstract

No abstract