In order to reduce the negative effect of lightweighting of suspension components on vehicle dynamic performance, the control arm and torsion beam widely used in front and rear suspensions were taken as research objects for studying the lightweight design method of suspension components. Mesh morphing technology was employed to define design variables. Meanwhile, the rigid–flexible coupling vehicle model with flexible control arm and torsion beam was built for vehicle dynamic simulations. The total weight of control arm and torsion beam was taken as optimization objective, as well as ride comfort and handling stability performance indexes. In addition, the fatigue life, stiffness, and modal frequency of control arm and torsion beam were taken as the constraints. Then, Kriging model and NSGA-II were adopted to perform the multi-objective optimization of control arm and torsion beam for determining the lightweight scheme. By comparing the optimized and original design, it indicates that the weight of the optimized control arm and torsion beam are reduced 0.505 kg and 1.189 kg, respectively, while structural performance and vehicle performance satisfy the design requirement. The proposed multi-objective optimization method achieves a remarkable mass reduction, and proves to be feasible and effective for lightweight design of suspension components.
The lightweight design of vehicle components is regarded as a complex optimization problem, which usually needs to achieve two or more optimization objectives. It can be firstly solved by a multi-objective optimization algorithm for generating Pareto solutions, before then seeking the optimal design. However, it is difficult to determine the optimal design for lack of engineering knowledge about ideal and nadir values. Therefore, this paper proposes a multi-objective optimization procedure combined with the NSGA-II algorithm with entropy weighted TOPSIS for the lightweight design of the dump truck carriage. The finite element model of the dump truck carriage was firstly developed for modal analysis under unconstrained free state and strength analysis under the full load and lifting conditions. On this basis, the multi-objective lightweight optimization of the dump truck carriage was carried out based on the Kriging surrogate model and the NSGA-II algorithm. Then, the entropy weight TOPSIS method was employed to select the optimal design of the dump truck from Pareto solutions. The results show that the optimized dump truck carriage achieves a remarkable mass reduction of 81 kg, as much as 3.7%, while its first-order natural frequency and strength performance are slightly improved compared with the original model. Accordingly, the proposed procedure provides an effective way for vehicle lightweight design.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.