Samples of ash from the 18 May 1980 eruption of Mount St. Helens were collected from several locations in eastern Washington and Montana. The ash was subjected to a variety of analyses to determine its chemical, physical, mineralogical, and biological characteristics. Chemically, the ash samples were of dacitic composition. Particle size data showed bimodal distributions and differed considerably with location. However, all samples contained comparable amounts of particles less than 3.5 micrometers in diameter (respirable fraction). Mineralogically, the samples ranged from almost totally glassy to almost totally crystalline. Crystalline samples were dominated by plagioclase feldspar (andesine) and orthopyroxene (hypersthene), with smaller amounts of titanomagnetite and hornblende. All but one of the samples contained from less than 1 percent to 3 percent free crystalline silica (quartz, trydimite, or cristobalite) in both the bulk samples and 1 to 2 percent in the fractions smaller than 3.5 micrometers. The long-lived natural radionuclide content of the ash was comparable to that of crustal material; however, relatively large concentrations of short-lived radon daughters were present and polonium-210 content was inversely correlated with particle size. In vitro biological tests showed the ash to be nontoxic to alveolar macrophages, which are an important part of the lungs' natural clearance mechanism. On the basis of a substantial body of data that has shown a correlation between macrophage cytotoxicity and fibrogenicity of minerals, the ash is not predicted to be highly fibrogenic.

No abstract

A new approach to fundamental parameter calculations has been devised which makes use of incoherent and coherent backscatter intensities from the excitation radiation. The backscatter results from all sample constituents, and thus provides information on total sample mass as well as on bulk sample composition. By appropriately using the scatter intensities in fundamental parameter matrix calculations, accurate analyses of “unknown“ samples can be obtained without prior knowledge of the sample matrix. The backscatter with fundamental parameter (BFP) method is especially advantageous for biological, geological and environmental samples because of their bulk quantities of carbon, oxygen, and other light elements which cannot be explicitly determined for traditional fundamental parameter calculations.

No abstract

No abstract