The authenticity, the grape variety, the geographical origin, and the year of vintage of wines produced in Germany were investigated by (1)H NMR spectroscopy in combination with several steps of multivariate data analysis including principal component analysis (PCA), linear discrimination analysis (LDA), and multivariate analysis of variance (MANOVA) together with cross-validation (CV) embedded in a Monte Carlo resampling approach (MC) and others. A total of about 600 wines were selected and carefully collected from five wine-growing areas in the southern and southwestern parts of Germany. Simultaneous saturation of the resonances of water and ethanol by application of a low-power eight-frequency band irradiation using shaped pulses allowed for high receiver gain settings and hence optimized signal-to-noise ratios. Correct prediction of classification of the grape varieties of Pinot noir, Lemberger, Pinot blanc/Pinot gris, Müller-Thurgau, Riesling, and Gewürztraminer of 95% in the wine panel was achieved. The classification of the vintage of all analyzed wines resulted in correct predictions of 97 and 96%, respectively, for vintage 2008 (n = 318) and 2009 (n = 265). The geographic origin of all wines from the largest German wine-producing regions, Rheinpfalz, Rheinhessen, Mosel, Baden, and Württemberg, could be predicted 89% correctly on average. Each NMR spectrum could be regarded as the individual "fingerprint" of a wine sample, which includes information about variety, origin, vintage, physiological state, technological treatment, and others.

No abstract

No abstract

BackgroundEver since Gay-Lussac's time, the alcoholic strength by volume (% vol) has been determined by using densimetric measurements. The typical reference procedure involves distillation followed by pycnometry, which is comparably labour-intensive and therefore expensive. At present, infrared (IR) spectroscopy in combination with multivariate regression is widely applied as a screening procedure, which allows one to determine alcoholic strength in less than 2 min without any sample preparation. The disadvantage is the relatively large investment for Fourier transform (FT) IR or near-IR instruments, and the need for matrix-dependent calibration. In this study, we apply a much simpler device consisting of a patented multiple-beam infrared sensor in combination with a flow-through cell for automated alcohol analysis, which is available in a portable version that allows for on-site measurements.ResultsDuring method validation, the precision of the infrared sensor was found to be equal to or better than densimetric or FTIR methods. For example, the average repeatability, as determined in 6 different wine samples, was 0.05% vol and the relative standard deviation was below 0.2%. Accuracy was ensured by analyzing 260 different alcoholic beverages in comparison to densimetric or FTIR results. The correlation was linear over the entire range from alcohol-free beers up to high-proof spirits, and the results were in substantial agreement (R = 0.99981, p < 0.0001, RMSE = 0.279% vol). The applicability of the device was further proven for the analysis of wines during fermentation, and for the determination of unrecorded alcohol (i.e. non-commercial or illicit products).ConclusionsThe flow-through infrared device is much easier to handle than typical reference procedures, while time-consuming sample preparation steps such as distillation are not necessary. Therefore, the alcoholic strength can be economically and quickly controlled (requiring less than 60 s per sample). The device also gives the opportunity for mobile on-site control in the context of labelling control of wine, beer and spirits, the process monitoring of fermentations, or the evaluation of unrecorded alcohols.

So-called energy drinks with very high amounts of taurine (up to 4000 mg/l are usually granted by certificates of exemption) are increasingly offered on the market. To control the currently valid maximum limits of taurine in energy drinks, a simple and rapid analytical method is required to use it routinely in food monitoring. In this article, we describe a fast and efficient analytical method (FTIR-spectroscopy) that is able to reliably characterize and quantify taurine in energy drinks. The determination of taurine in energy drinks by FTIR was compared with amino acid analyzer (ion chromatography with ninhydrin-postcolumn derivatization). During analysis of 80 energy drinks, a median concentration of 3180 mg/l was found in alcohol-free products, 314 mg/l in energy drinks with spirits, 151 mg/l in beer-containing drinks and 305 mg/l in beverages with wine. Risk analysis of these products is difficult due to the lack of valid toxicological information about taurine and its interferences with other ingredients of energy drinks (for example caffeine and alcohol). So far, the high taurine concentrations of energy drinks in comparison to the rest of the diet are scientifically doubtful, as the advertised physiological effects and the value of supplemented taurine are unproven.