The delineation of high flood hazard zones within a flood plain is usually independent of the hydraulic parameters that constitute a life threatening situation. In order to defme human instability in high hazard areas, a study was conducted to identif' when an adult human could not stand or maneuver in a simulated flood flow. An analysis was performed on a rigid body monolith resulting in a toppling hazard envelope curve (velocity vs. depth). A 120 lb monolith was then constructed and tested to relate the actual flow velocity and depth at toppling to theory. A series of human subjects (90-20 1 ibs) were placed in a recirculating flume and tested to determine the velocity and depth of flow that caused their instability.The test results determined that the product number, which is the product of the velocity and depth at toppling of the monolith, closely compared to the theoretical envelope curve. The monolith results represent the lower limit of human stability. Also, the product number appeared to be a predictor of human instability in flood flow. A relationship was developed to estimate the product number at which a human subject becomes unstable as a function of the height and weight of the subject. (KEY TERMS: flood hazard; human stability; product number.) 1Paper No. 89010 of the Water Resources Bulletin. Discussions are open until April 1, 1990. 2Respectively, Professor,
A series of flume tests were conducted to determine the flow resistance of angular shaped riprap in steep channels. Flow resistance was expressed in terms of the Darcy‐Weisbach friction factor and the Manning's roughness coefficient. Prototype channels of 4 ft. (1.2 m) and 12 ft. (3.7 m) in width were constructed at slopes ranging from 0.01 to 0.20. The channel beds were comprised of angular riprap of median diameters of 1, 2, 4, 5, and 6 inches (2.59, 5.59, 10.41, 12.95, and 15.75 cms). The Darcy‐Weisbach and Manning's coefficients were determined for each test condition prior to bed failure. The resulting Darcy‐Weisbach coefficients were related to the channel energy gradient and the bed relative submergence for highly turbulent flow. Also, Manning's roughness coefficients were related to the product of the median stone diameter and energy gradient. Because of the angular shape of the riprap and the wedging and/or packing of the bed materials, the resistance to flow was found to exceed the flow resistance values predicted by previous studies. Expressions were presented for estimating the resistance to flow for angular riprap in steep channels.
An investigation was conducted to determine the feasibility of applying thermodilution technology to discharge measurements in small open channels. A series of tests were performed in which the time‐temperature dilution curves were recorded and analyzed. The independent variables included the channel discharge, the injectate drop height, the volume of tracer, and the mixing distance. Flows ranged from 0.67 cfs to 2.45 cfs with Froude numbers less than 0.30. The results indicated that the thermodilution technique is a feasible method for discharge measurement. It was determined that a heat content, 1°, of 40°C provides a design criteria in which the mixing distance was related to the flow depth and discharge in a rectangular channel. An empirical expression was derived to determine the approximate mixing distance as a function of the flow depth.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.